Mast radiator

Mast radiator
A typical mast radiator in Chapel Hill, North Carolina. The high RF voltage on the mast can deliver a dangerous electrical shock to anyone touching it, so the base is surrounded by a fence to prevent access.
Base feed: Radio frequency power is fed to the mast by a wire attached to it, which comes from an antenna tuning unit inside the "helix building" at right. The brown ceramic insulator at the base keeps the mast isolated from the ground. On the left there is an earthing switch and a spark gap for lightning protection.
The Blosenbergturm in Beromünster, Switzerland - a radiating tower insulated against ground

A mast radiator (or 'radiating tower') is a radio mast or tower in which the whole structure itself functions as an antenna. This design is commonly used for transmitting antennas operating at low frequencies, in the VLF, LF and MF ranges, in particular those used for AM broadcasting. The metal mast is electrically connected to the transmitter. Its base is usually mounted on a nonconductive support to insulate it from the ground. A mast radiator is a form of monopole antenna.

Contents

Design considerations

Design

Most mast radiators are built as guyed masts insulated from the ground at the base. Steel lattice masts, of triangular cross-section, are the most common type. Square lattice masts and tubular masts are also sometimes used. To ensure that the tower is a continuous conductor, the tower's structural sections are electrically bonded at the joints by short copper jumpers which are soldered to each side.

At its base, the mast is usually mounted on a thick ceramic insulator, which has the compressive strength to support the tower's weight and the dielectric strength to withstand the high RF voltage applied by the transmitter. The RF power to drive the antenna is supplied by an antenna tuner unit, usually housed in a small building called a helix building next to the mast, and the cable supplying the current is simply bolted to the tower. The actual transmitter is usually located in a separate building, which supplies RF power to the helix building via a transmission line

Free-standing towers are also used as radiating structures. These towers can have a triangular or a square cross section. One of the best-known radiating towers is the Blosenbergturm in Beromünster, Switzerland. Masts of glass fibre are sometimes used for some small constructions.

Mast height

The ideal height of a mast radiator depends on transmission frequency, demographics for the location, and terrain. For radio systems in the longwave and mediumwave range the value of the height should be in the range between one sixth and five eighths of the wavelength, with favourite values at the quarter or the half of the radiated wavelength. When this is not always possible, masts with a loading coil, 'capacity hat' or similar loading arrangement are used. The quarter-wave mast is a form of monopole antenna.

The height of the mast determines the radiation properties. For high power transmitters in the MW range, masts with heights around half of the radiated wavelength are preferred because they focus the radiated power better to the ground than structures with heights of quarter wavelengths, which are preferred for economical reasons for low power medium wave transmitters. A focus of radiated power towards the ground is much desired on frequencies below 3 megahertz, because groundwave propagation is very stable. Masts longer than five eighths of the wavelength are normally not used, because they show bad vertical radiation patterns, so masts for mediumwave transmitters do not normally exceed 300 metres. For longwave transmitters, however, the construction of masts with heights of half-wave wavelength is, because of economical reasons (and perhaps problems with the flight safety), in most cases impossible. The only so far realized radio mast for longwave with a height of the half length of the radiated wavelength was the Warszawa Radio Mast at Konstantynów, Poland. At the time of its collapse in 1991 it was the tallest manmade structure in the world, at 646.38 metres (2,120.67 ft) tall. For frequencies below longwave masts are electrically enlarged by loading coils or capacity hats on the top, because masts of even quarter wave length would be too high.

Feed arrangements

There are three ways of feeding a mast radiator from a transmitter:

  • Base feed: the mast is supported on an insulator, and the transmitter is connected to the mast just above it;
  • Shunt feed: the mast is grounded and the transmitter feeds it via a wire connected to the mast part way up. (This is a similar approach, on a larger scale, to the 'gamma match' popular among amateur radio operators for VHF and UHF amateur radio antennas.)
  • Multiple feed: the structure is divided into two (or more) sections with insulators between, each independently fed. This collinear arrangement enhances low-angle (ground wave) radiation and reduces high-angle (sky wave) radiation. This increases the distance to the mush zone where the ground wave and sky wave are at similar strength at night. This type of antenna is known as an anti-fading aerial (see below).

There is usually an antenna matching unit to match the impedance of the transmitter or feeder to the antenna. Depending on the power involved, this may be a small box or a hut or building. It will typically contain an L-network to transform the modulus of impedance, and a coil or capacitor in series with the mast connection to 'tune out' any reactive component.

Location on transmission facility

At some facilities, especially the older and higher-powered installations, the mast radiator may be located at some distance of the transmitter building, in order to reduce the field strength induced by the mast into the building, and to prevent the building from distorting the mast's radiation pattern. Between the transmitter building and the antenna matching unit next to the mast radiator, there is a feeder: either an underground coaxial cable or an overhead wire 'cage' feeder.

At facilities with multiple masts, spacings are typically smaller, in order to fit them into the available space.

At modern transmitters or at low power transmitters situated in very small transmitter buildings the transmitter, matching unit and mast radiator can be very close together and even in the same building. This measure saves on feeders, land area and increases the efficiency of the transmitter, if only one mast radiator is in use.

At most facilities the mast radiator is on a separate base close to the antenna matching unit, but it can be sometimes set up the roof of it. This is for example the case at the main transmission mast of the Mühlacker radio transmitter and the main transmission mast of the Ismaning radio transmitter.

For a good groundwave propagation, mast radiators should be built always on a large flat area with good ground conductivity and if possible without inclination. The construction of a mast radiator on the top of a building or a tower, whose height is in the same magnitude range as the wavelengths being transmitted gives a bad groundwave propagation. So mast radiators are (in contrast to FM broadcasting antennas) normally not installed on the top of buildings or towers. Nevertheless in rare cases mast radiators for low power transmissions are installed on top of buildings. So some lighthouses like Reykjanesviti carry a mast radiator for a longwave radio beacon on its roof. Also low-power broadcasting stations uses and used such arrangements. The best-known are WGSO in New Orleans and KSBN (AM) on the Delaney Building in Spokane. In Europe the low-power broadcasting station at Campobasso uses a mast radiator on a castle.

Fencing

Mast radiators, as with all other equipment showing over 42 volts on exposed components within 4 metres of the ground,[where?] are required to be fenced in. Sometimes wooden fences are used in order to prevent signal interference, which could occur due to currents induced by radio signals in metallic fences. If the mast radiator is mounted on the top of the helix building, which must be over four metres in height; or the mast is grounded, with the feed being located not less than four metres above the ground, a fence is not required. Nevertheless it is always recommended to fence in any mast radiator in order to prevent unauthorized climbing.

Ancillary connections

A mast radiator may need various electrical connections other than the transmitter feed line. Such connections include static drain chokes for lightning protection, power supplies for aircraft warning lamps, and coaxial feeders for ancillary antennas mounted on the mast. A variety of techniques is used to 'isolate' these connections from the high RF voltage on the mast, such as chokes, parallel tuned circuits and coupling loops, on a base-fed mast. On a shunt-fed mast, where the base is grounded, no such measures are necessary.

Anti-fading aerials

An anti-fading aerial is a transmission aerial for long- and mediumwave with a flat vertical radiation pattern, in order to push the mush zone far away from the transmitter site. An anti-fading aerial must reduce radiation at elevations of more than 50 degrees as much as possible.

In its simplest form it is an aerial of half wavelength. Such an aerial should be as thin as possible. In early days therefore a wire was hung up in a wood framework tower. Nowadays a radio mast is therefore used, which is fed at its foot and in a certain height. Therefore the radio mast must be insulated against ground and be divided by a separation insulator electrically in two parts, where for feeding of the upper part either a cable inside the mast construction or the ladder, which must be mounted insulated is used. The medium wave transmitters Mühlacker, Wolfsheim and Hamburg use such aerials. There are also radio masts for fading reducing aerials with two separation insulators as at Ismaning.

Because such separation insulators are more sensitive as the whole other construction of the radio mast, bigger horizontal forces, which could be generated by wind caused oscillations, should be inhibited. Therefore some radio mast with built in separation insulators have oscillation dampers just above the separation insulator. You find such device at the radio masts of the transmitters Wolfsheim, Hamburg and Ismaning.

Another possibility for reducing an anti-fading aerial is the usage of dipoles hung up in a certain height above ground. A further possibility of the realization an anti-fading aerial is a circle group aerial. Therefore many mast radiators were arranged on a circle and fed in equal phase. With such facilities very flat radiation patterns could be realized, although they are very expensive, because multiple radio masts are required. Taldom transmitter and Tulagino transmitter in Russia are obviously the only radio stations using such an antenna. In earlier days longwave transmitter Orlunda in Sweden also used such an antenna.

Records

The tallest mast radiator ever built was the Warsaw Radio Mast at Konstantynow, Poland. It was 646.38 metres high but collapsed in 1991. Currently the masts of the Lualualei VLF transmitter, at 458.11 metres, are the tallest mast radiators insulated against ground. In contrast to the Warsaw Radio Mast, the Lualualei antenna uses extensive electrical lengthening measures. The tallest mast radiator not using electrical lengthening may be the Hellissandur longwave radio mast. It is 411.48 metres high.

See also



Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Warsaw radio mast — Infobox building building name=Warsaw Radio Mast caption=The Warsaw radio mast in Konstantynów building type=Mast radiator insulated against ground location=Konstantynów, Gąbin, Poland coordinates=coord|display=inline,title|52|22|14|N|19|48|23|E|t… …   Wikipedia

  • Longwave radio mast Hellissandur — Infobox building building name=Longwave radio mast Hellissandur caption= building type=mast radiator insulated against ground location=Hellissandur, Iceland coordinates=coord|display=inline,title|64|54|25|N|23|55|19|W|type:landmark Status=Built… …   Wikipedia

  • Eldorado do Sul RBS Radio Mast — ( also known as Sans Souci Mast or as Antena do Parque Técnico Maurício Sirotsky Sobrinho) is the tallest man made object in Brazil. Eldorado do Sul RBS Radio Mast is used by Rede Brasil Sul Communication Group for medium wave broadcasting on 720 …   Wikipedia

  • WJJY TV Mast — The WJJY TV Mast was a 1,610 foot (491 m) guyed mast used for TV transmissions at Bluffs, Illinois, United States. It was used by Look Television Corporation for the broadcasts of WJJY TV in Jacksonville, Illinois.The antenna was an experimental… …   Wikipedia

  • Monopole antenna — Mast radiator monopole antenna used for broadcasting. AM radio station WARE, Warren, Massachusetts, USA. A monopole antenna is a class of radio antenna consisting of a straight rod shaped conductor, often mounted perpendicularly over some type of …   Wikipedia

  • Radio masts and towers — Masts of the Rugby VLF transmitter in England …   Wikipedia

  • Antenna (radio) — Whip antenna on car …   Wikipedia

  • Hoher Meissner transmitter — is a facility for mediumwave, FM and TV broadcasting on Hoher Meissner mountain in Northern Hesse. Hoher Meissner transmitter was inaugurated in 1951.For the mediumwave transmission of Hoher Meissner transmitter from 1951 to 1995 a 150 metre tall …   Wikipedia

  • Marcus Island LORAN-C transmitter — Marcus Island overview with transmitter Marcus Island LORAN C Mast (1st) General information …   Wikipedia

  • Ravensburg-Horgenzell transmitter — is a mediumwave broadcasting facility of Deutsche Telekom used for transmitting the program of Deutschlandfunk on the area of community Horgenzell nothwest of Ravensburg in Baden Württemberg. It was inaugurated on August 23, 1951 and used until… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”