Cupola furnace

Cupola furnace
A cupola furnace in operation at Wayne State University, in Detroit, Michigan

A Cupola or Cupola furnace is a melting device used in foundries that can be used to melt cast iron, ni-resist iron and some bronzes. The cupola can be made almost any practical size. The size of a cupola is expressed in diameters and can range from 1.5 to 13 feet (0.5 to 4.0 m)[1]. The overall shape is cylindrical and the equipment is arranged vertically, usually supported by four legs. The overall look is similar to a large smokestack.

The bottom of the cylinder is fitted with doors which swing down and out to 'drop bottom'. The top where gases escape can be open or fitted with a cap to prevent rain from entering the cupola. To control emissions a cupola may be fitted with a cap that is designed to pull the gases into a device to cool the gasses and remove particulate matter.

The shell of the cupola, being usually made of steel, has refractory brick and refractory patching material lining it. The bottom is lined in a similar manner but often a clay and sand mixture ("bod") may be used, as this lining is temporary. Finely divided coal ("sea coal") can be mixed with the clay lining so when heated the coal decomposes and the bod becomes slightly friable, easing the opening up of the tap holes.[2] The bottom lining is compressed or 'rammed' against the bottom doors. Some cupolas are fitted with cooling jackets to keep the sides cool and with oxygen injection to make the coke fire burn hotter.

Contents

History

The first known cupola furnace was made by René-Antoine Ferchault de Réaumur around 1720,[3] though evidence suggests that this technique was in use in China as far back as the 3rd and 2nd centuries BC.[4][5]

Operation

To begin a production run, called a 'cupola campaign', the furnace is filled with layers of coke and ignited with torches. Some smaller cupolas may be ignited with wood to start the coke burning. When the coke is ignited, air is introduced to the coke bed through ports in the sides called tuyeres.

When the coke is very hot, solid pieces of metal are charged into the furnace through an opening in the top. The metal is alternated with additional layers of fresh coke. Limestone is added to act as a flux. As the heat rises within the stack the metal is melted. It drips down through the coke bed to collect in a pool at the bottom, just above the bottom doors. During the melting proses a thermodynamic reaction takes place between the fuel and the blast air. The carbon in the coke combines with the oxygen in the air to form carbon monoxide. The carbon monoxide further burns to form carbon dioxide. Some of the carbon is picked up by the falling droplets of molten metal which raises the carbon content of the iron. Silicon carbide and ferromanganese briquettes may also be added to the charge materials. The silicon carbide dissociates and carbon and silicon enters into the molten metal. Likewise the ferromanganese melts and is combined into the pool of liquid iron in the 'well' at the bottom of the cupola. Additions to the molten iron such as ferromanganese, ferrosilicon, Silicon carbide and other alloying agents are used to alter the molten iron to conform to the needs of the castings at hand.

The operator of the cupola is known as the 'Cupola Tender' or "Furnace Master". During the operation of a tapped cupola (cupolas may vary in this regard)the tender observes the amount of iron rising in the well of the cupola. When the metal level is sufficiently high, the cupola tender opens the "tap hole" to let the metal flow into a ladle or other container to hold the molten metal. When enough metal is drawn off the "tap hole" is plugged with a refractory plug made of clay[6].

The cupola tender observes the furnace through the sight glass or peep sight in the tuyeres. Slag will rise to the top of the pool of iron being formed. A slag hole, located higher up on the cylinder of the furnace, and usually to the rear or side of the tap hole, is opened to let the slag flow out. The viscosity is low (with proper fluxing) and the red hot molten slag will flow easily. Sometimes the slag which runs out the slag hole is collected in a small cup shaped tool, allowed to cool and harden. It is fractured and visually examined. With acid refractory lined cupolas a greenish colored slag means the fluxing is proper and adequate. In basic refractory lined cupolas the slag is brown.

After the cupola has produced enough metal to supply the foundry with its needs, the bottom is opened, or 'dropped' and the remaining materials fall to the floor between the legs. This material is allowed to cool and subsequently removed. The cupola can be used over and over. A 'campaign' may last a few hours, a day, weeks or even months.

When the operation is over, the blast is shut off and the prop under the bottom door is knocked down so that the bottom plates swing open. This enables the cupola remains to drop to the floor or into a bucket. They are then quenched and removed from underneath the cupola.

Quality Control

During the production, samples may be taken from the metal and poured into small molds. A chill wedge is often poured to monitor the iron quality. These small, approx 18 mm (3/4") wide x 38 mm (1-12") tall triangular shaped pieces are allowed to cool until the metal has solidified. They are then extracted from the sand mold and quenched in water, wide end first. After cooling in the manned the wedges are fractured and the metal coloration is assessed. A typical fracture will have a whitish color towards the thin area of the wedge and grayish color towards the wide end. The width of the wedge at the point of demarcation between the white and gray areas is measured and compared to normal results for particular iron tensile strengths. This visual method serves as a control measurement.

References

  1. ^ Intelligent Control of Cupola Melting, E.D. Larsen, Et. All, Lockheed Martin Idaho Technologies Company, June 1997 [1]
  2. ^ Kirk, Edward (1899). "Cupola management". Cupola Furnace - A Practical Treatise on the Construction and Management of Foundry Cupolas. Philadelphia, PA: Baird. p. 95. OCLC 2884198. 
  3. ^ Encyclopedia Britannica
  4. ^ Wagner, Donald B. (2001). The State and the Iron Industry in Han China. Copenhagen: Nordic Institute of Asian Studies Publishing. ISBN 87-87062-83-6.
  5. ^ http://www.staff.hum.ku.dk/dbwagner/cice/cice.html Cast Iron in China and Europe retrieved 2010 Dec 10
  6. ^ http://www.hdowns.co.uk/hdweb_melting_page.htm

External links


Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • cupola furnace — ▪ metallurgy       in steelmaking, a vertical cylindrical furnace used for melting iron either for casting or for charging in other furnaces.       René Antoine Ferchault de Réaumur built the first cupola furnace on record, in France, about 1720 …   Universalium

  • Cupola (disambiguation) — Cupola, a diminutive of the Latin cupa (barrel) and thus meaning little barrel , is used for dome shaped items, including: An architectural dome element Cupola, a (usually dome shaped) structure located on top of a larger roof or dome (for a roof …   Wikipedia

  • cupola — [ kju:pələ] noun 1》 a rounded dome forming or adorning a roof or ceiling. 2》 a gun turret. 3》 (also cupola furnace) a cylindrical furnace for refining metals. Derivatives cupolaed ləd adjective Origin C16: Ital., from late L. cupula small cask or …   English new terms dictionary

  • cupola — n. 1 a a rounded dome forming a roof or ceiling. b a small rounded dome adorning a roof. 2 a revolving dome protecting mounted guns on a warship or in a fort. 3 (in full cupola furnace) a furnace for melting metals. Derivatives: cupolaed adj.… …   Useful english dictionary

  • Cupola — Cu po*la (k? p? l?), n.; pl. {Cupolas} ( l?z). [It. cupola, LL. cupula, cuppula (cf. L. cupula little tub). fr. cupa, cuppa, cup; cf. L. cupa tub. So called on account of its resemblance to a cup turned over. See {Cup}, and cf. {Cupule}.] 1.… …   The Collaborative International Dictionary of English

  • cupola — ► NOUN 1) a rounded dome forming or adorning a roof or ceiling. 2) a gun turret. 3) a cylindrical furnace for refining metals. ORIGIN Latin cupula small cask …   English terms dictionary

  • cupola — [kyo͞o′pə lə] n. [It < L cupula, dim. of cupa: see CUP] 1. a rounded roof or ceiling 2. a small domelike structure on a roof 3. a small furnace for melting metals 4. any of various dome shaped structures cupolaed [kyo͞o′pələd] adj …   English World dictionary

  • cupola — /kyooh peuh leuh/, n. 1. Archit. a. a light structure on a dome or roof, serving as a belfry, lantern, or belvedere. b. a dome, esp. one covering a circular or polygonal area. 2. any of various domelike structures. 3. Metall. a vertical furnace… …   Universalium

  • cupola — noun Etymology: Italian, from Latin cupula, diminutive of cupa tub Date: 1549 1. a. a rounded vault resting on a usually circular base and forming a roof or a ceiling b. a small structure built …   New Collegiate Dictionary

  • cupola — cu•po•la [[t]ˈkyu pə lə[/t]] n. pl. las 1) archit. a) a light structure on a dome or roof, serving as a belfry, lantern, or belvedere b) a dome, esp. one covering a circular or polygonal area 2) any of various domelike structures 3) mel a… …   From formal English to slang

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”