Diindenoperylene

Diindenoperylene
Diindenoperylene
Identifiers
Abbreviations DIP
CAS number 188-94-3 YesY
PubChem 96712
Jmol-3D images Image 1
Properties
Molecular formula C32H16
Molar mass 400.47 g mol−1
Appearance Orange solid
Boiling point

>330 °C (sublimation)

 YesY (verify) (what is: YesY/N?)
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa)
Infobox references

Diindenoperylene (DIP) is an organic semiconductor which receives attention because of its potential application in optoelectronics (solar cells, OLEDs) and electronics (RFID tags). DIP is a planar perylene derivative with two indeno-groups attached to opposite sides of the perylene core. Its chemical formula is C32H16, the full chemical name is diindeno[1,2,3-cd:1',2',3'-lm]perylene. Its chemical synthesis has been described.[1][2]

The molecular weight is 400.48 g/mol, the dimensions of the molecule in its plane are ~18.4×7 Å.[3] and its sublimation temperature is above 330 °C.[4] It is non-polar and therefore only slightly soluble, for example in acetone.

DIP is a red dye[5] and has been used as active material for optical recording.[6] Because of its ‘perylene-type’ optical emission in the visible spectrum, it has also been used in organic light emitting diodes.[7] Organic field effect transistors of DIP have been studied.[8] The charge carrier mobility achieved was up to 0.1 cm²/(V·s) for thin film transistors with silicon dioxide as gate dielectric, making DIP a good candidate for further optimisation.[9]

The structure of bulk DIP crystals has recently been studied by Pflaum et al., who found two distinct phases at room temperature and at temperatures above 160 °C. In thin films for growth ‘near equilibrium’ (at substrate temperature of about 130 °C) by organic molecular beam deposition (OMBD), DIP has been shown to order very well.[2][10] The structure of thin DIP films has been characterized ‘post-growth’,[2][11][12][13] with structures differing from the room-temperature bulk structure. These thin-film structures depend on the substrate used, and also on the substrate temperature during growth.[10]

References

  1. ^ J. von Braun, G. Manz, in Deutsches Reichspatentamt, Berlin. (Germany, 1934).
  2. ^ a b c E. Clar, Polycyclic hydrocarbons (Academic Press, London, New York, 1964), p. 2
  3. ^ Dürr, A. C.; Schreiber, F.; Münch, M.; Karl, N.; Krause, B.; Kruppa, V.; Dosch, H. (2002). "High structural order in thin films of the organic semiconductor diindenoperylene". Applied Physics Letters 81 (12): 2276. doi:10.1063/1.1508436. 
  4. ^ A. C. Dürr, Ph.D. thesis, Universität Stuttgart (2002)
  5. ^ Heilig, M; Domhan, M; Port, H (2004). "Optical properties and morphology of thin diindenoperylene films". Journal of Luminescence 110 (4): 290. doi:10.1016/j.jlumin.2004.08.023. 
  6. ^ H. E. Simmons. (1987)
  7. ^ H. Antoniadis, A. J. Bard. (Hewlett-Packard Company & The Board of Regents of The University of Palo Alto, CA, 1997)
  8. ^ M. Münch, Ph.D. thesis, Universität Stuttgart (2001)
  9. ^ N. Karl, in Organic Electronic Materials R. Farchioni, G. Grosso, Eds. (Springer, Berlin, 2001), vol. II, ISBN 3540667210 pp. 283 ff.
  10. ^ a b Kowarik, S.; Gerlach, A.; Sellner, S.; Schreiber, F.; Cavalcanti, L.; Konovalov, O. (2006). "Real-Time Observation of Structural and Orientational Transitions during Growth of Organic Thin Films". Physical Review Letters 96 (12): 125504. Bibcode 2006PhRvL..96l5504K. doi:10.1103/PhysRevLett.96.125504. PMID 16605925. 
  11. ^ Dürr, A.; Schreiber, F.; Ritley, K.; Kruppa, V.; Krug, J.; Dosch, H.; Struth, B. (2003). "Rapid Roughening in Thin Film Growth of an Organic Semiconductor (Diindenoperylene)". Physical Review Letters 90 (1): 016104. Bibcode 2003PhRvL..90a6104D. doi:10.1103/PhysRevLett.90.016104. PMID 12570630. 
  12. ^ Dürr, A.; Koch, N.; Kelsch, M.; Rühm, A.; Ghijsen, J.; Johnson, R.; Pireaux, J.-J.; Schwartz, J. et al. (2003). "Interplay between morphology, structure, and electronic properties at diindenoperylene-gold interfaces". Physical Review B 68 (11): 115428. doi:10.1103/PhysRevB.68.115428. 
  13. ^ Hoshino, A (1991). "Epitaxial growth of organic crystals on organic substrates — polynuclear aromatic hydrocarbons". Journal of Crystal Growth 115: 826. doi:10.1016/0022-0248(91)90854-X. 

Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • Diindénopérylène — Structure du DIP. Général Nom IUPAC diindéno[1,2,3 cd:1 ,2 ,3 lm]pérylène …   Wikipédia en Français

  • Aromatic hydrocarbon — Arene redirects here. For other uses, see Arene (disambiguation). An aromatic hydrocarbon or arene[1] (or sometimes aryl hydrocarbon)[2] is a hydrocarbon with alternating double and single bonds between carbon atoms. The term aromatic was… …   Wikipedia

  • Naphthalene — Not to be confused with Naphtha, a broad term describing liquid hydrocarbon mixtures. Naphthalene …   Wikipedia

  • DIP — may refer to: Contents 1 As a three letter acronym 1.1 In science and technology 1.1.1 In computer scie …   Wikipedia

  • Coronene — Other names …   Wikipedia

  • Polycyclic aromatic hydrocarbon — An illustration of typical polycyclic aromatic hydrocarbons. Clockwise from top left: benz(e)acephenanthrylene, pyrene and dibenz(ah)anthracene …   Wikipedia

  • Acenaphthene — IUPAC …   Wikipedia

  • Acenaphthylene — IUPAC name acenaphthylene …   Wikipedia

  • Helicene — Helicenes in organic chemistry are ortho condensed polycyclic aromatic compounds in which benzene rings or other aromatics are angularly annulated to give helically shaped molecules. The chemistry of helicenes has attracted continuing attention… …   Wikipedia

  • Corannulene — IUPAC name …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”