- Nickel-cadmium battery vented cell type
Vented cell (wet cell, flooded cell) is a type of
nickel-cadmium batterythat is used when large capacities and discharge rates are required. The term "vented" refers to a difference to common NiCd batteries which are "sealed".
They are used in aviation, rail and mass transit,
backup powerfor telecoms, engine starting for backup turbines etc. Using vented cell NiCd batteries results in reduction in size, weight and maintenance requirements over other types of batteries. Vented cell NiCd batteries have long lives (up to 20 years or more, depending on type) and operate at extreme temperatures (from -40°C to +70°C).
Structure and chemistry
A steel battery box contains the cells connected in series to gain the desired voltage (1.2V per cell nominal). Cells are made of light durable
polyamideor nylonwith multiple nickel-cadmium plates welded together for each electrode inside. A separator or liner made of siliconerubber acts as an insulator and a gas barrier between the electrodes. Cells are flooded with an electrolyteof 30% aqueous solutionof potassium hydroxide( KOH). The specific gravityof the electrolyte does not indicate if the battery is empty or full but changes mainly with venting of water. The top of the cell contains a space for excess electrolyte and a pressure release vent. Large nickel plated copper studs and thick interconnecting links assure minimum electrical resistancefor the battery.
The venting of gases means that there must be an excess of water in the cells (hence the name flooded cells). This also means the lost water must be periodically replaced during maintenance. Depending on the charge-discharge cycles and type of battery this can mean a maintenance period of anything from a few months to a year. Because the chemistry affects the volume of the liquid, the level must be topped-up only at the end of the charge cycle when the battery is fully charged.
Vented cell voltage rises rapidly at the end of charge allowing for very simple charger circuitry to be used. Typically a battery is constant current charged at 1CA rate until all the cells have reached at least 1.55V. Another charge cycle follows at 0.1CA rate, again until all cells have reached 1.55V. The charge is finished with an Over Charge or top-up charge, typically for not less than 4 hours at 0.1CA rate. The purpose of the Over Charge is to expel as much if not all the gases collected on the electrodes, Hydrogen on the Anode and Oxygen on the Cathode, and some of these gases recombine to form water which in turn will raise the electrolyte level to its highest level after which it is safe to adjust the electrolyte levels. During the Over Charge or top-up charge the cell voltages will go beyond 1.6V and then slowly start to drop. No cell should rise above 1.71V (dry cell) or drop below 1.55V (gas-barrier broken).
Charging is done with vent caps loosened or open. A stuck vent might increase the pressure in the cell. It will also allow for refilling of water to correct levels before the end of the top-up charge while the charge current is still on. However cells should be closed again as soon as the vents have been cleaned and checked since carbon-dioxe dissolved from outside air carbonates the cells and ages the battery.
In an aircraft installation with a floating battery electrical system the regulator voltage is set to charge the battery at constant potential charge (typically 14 or 28 volts). If this voltage is set too high it will result in rapid water loss. A broken regulator diode will allow the charge voltage to rise well above this, causing a massive overcharge with boiling over of the electrolyte.
Battery maintenance period depends on the number of charge cycles, the type of charge and temperature conditions where the battery has been kept. Capacity testing is done with a constant current discharge of 1CA. For avionics batteries the limit for maintenance is 100% of rated capacity but in the older batteries (pre 1999) and some less efficient batteries it is considered 85% of the rated capacity. With the intervention of more technologically advanced materieals, some manufacturers are considering raising the 'end of life' capacity for High Power cells to 110% 1CA. The maintenance consists of equalizing the cells by individually short circuiting them. The battery is left overnight in this condition and charged up again with final check of liquid levels. Any cells which do not hold their capacity at the second capacity test will be replaced. With proper maintenance modern cells have a life time well beyond 20 years but most manufacturers recommend 5000 hours. The cells will age slowly due to carbon-dioxide carbonating the cells. To prevent this, the vents should be kept closed and pressure tested periodically.
A typical aircraft battery used for engine starting has been rated to deliver over 15 kilowatts of power for 15 seconds. The load operates at around the internal resistance of the battery and the voltage loss at battery is equal to the load. Essentially the battery can be short circuited and it is able to dissipate the heat generated by the internal resistance for this short period of time.
*General Electric, "Nickel-Cadmium Battery Application Engineering Handbook", 1971
*Marathon Battery Company, "Care and Maintenance of Nickel-Cadmium Batteries"
*SAFT, "NiCd Aircraft Batteries, Operating and Maintenance Manual (OMM)", 2002
* [http://www.saftbatteries.com/saft/portals/0/applications/aircraft/PDF/omm.pdf NiCd Aircraft Batteries, Operating and Maintenance Manual (PDF)]
Wikimedia Foundation. 2010.
Look at other dictionaries:
Nickel–cadmium battery (vented cell type) — Vented cell (wet cell, flooded cell) is a type of nickel–cadmium battery that is used when large capacities and high discharge rates are required. The term vented refers to a difference to common NiCd batteries which are sealed. They are used in… … Wikipedia
Nickel–cadmium battery — From top to bottom – Gumstick , AA, and AAA Ni–Cd batteries. specific energy 40–60 W·h/kg energy density 50–150 W·h/L specific power 150& … Wikipedia
Nickel-cadmium battery — Batteries caption=From top to bottom Gumstick , AA, and AAA NiCd batteries. EtoW = 40–60 Wh/kg EtoS = 50–150 Wh/L PtoW = 150W/kg CtoDE= 70%–90% [ [http://www.batteryuniversity.com/partone 11.htm Charging nickel based batteries ] ] EtoCP= ? US$… … Wikipedia
Battery (electricity) — For other uses, see Battery (disambiguation). Various cells and batteries (top left to bottom right): two AA, one D, one handheld ham radio battery, two 9 volt (PP3), two AAA, one C, one … Wikipedia
VRLA battery — A valve regulated (sealed) lead–acid battery A VRLA battery (valve regulated lead–acid battery) is a type of low maintenance lead–acid rechargeable battery. Because of their construction, VRLA batteries do not require regular addition of water to … Wikipedia
Electric vehicle battery — Further information: Rechargeable electricity storage system For the starting, lighting and ignition system battery of an automobile, see Automotive battery. A Mitsubishi i MiEV having its batteries installed in Japan … Wikipedia
environment — environmental, adj. environmentally, adv. /en vuy reuhn meuhnt, vuy euhrn /, n. 1. the aggregate of surrounding things, conditions, or influences; surroundings; milieu. 2. Ecol. the air, water, minerals, organisms, and all other external factors… … Universalium
Hydrogen — This article is about the chemistry of hydrogen. For the physics of atomic hydrogen, see Hydrogen atom. For other meanings, see Hydrogen (disambiguation). ← hydrogen → helium … Wikipedia