- Key telephone system
A key system or key telephone system is a multiline
telephonesystem typically used in small office environments.
Key systems are noted for their expandability and having individual line selection buttons for each connected phone line, however some features of a
private branch exchangesuch as dialable intercoms may also commonly be present.
Key systems can be built using three principal architectures:
* Electromechanical shared-control
* Electronic shared-control
* Independent keysets
Electromechanical shared-control key systems
Before the advent of large-scale integrated circuits, key systems were typically built out of electromechanical components (
relays) as were larger telephone switchingsystems.
The systems marketed in
North Americaas the 1A, 6A, 1A1 and the 1A2 Key Systemwere entirely typical and sold for many decades. The 1A family of Western Electric Company(WECo) key telephone units (KTUs) were in use in the 1950s. 1A equipment was primitive and required at least two KTUs per line; one for line termination and one for station (telephone instrument) termination. The telephone instrument commonly used by 1A systems was the WECo 300-series telephone. In the 1960s, 1A1 key systems simplified wiring with a single KTU for both line and station termination, and increased the features available to the users. As the 1A1 systems became commonplace, requirements for intercom features increased. The original intercom KTUs, WECo Model 207, were wired for a single talk link, that is, a single conversation on the intercom at a time. The WECo 6A dial intercom system provided two talk links and was often installed as the dial intercom in a 1A1 or 1A2 key system. Unfortunately, the 6A systems were very complex and prone to problems. They were also very expensive and never came much into favor. The advent of 1A2 technology in the 1970s tremendously simplified key system set up and maintenance. These continued to be used throughout the 1980s, though the arrival of electronic key systems with their easier installation and greater features signaled the end of all electromechanical key systems.
Two obscure key systems were used at airports for air traffic control communications, the 102 and 302 key systems. These were uniquely designed for communications between the air traffic control tower and radar approach control (RAPCON) or ground control approach (GCA), and included radio line connections.
Automatic Electric Companyalso sold a family of key telephone equipment, but it never gained the widespread use enjoyed by Western Electric equipment.
Electronic shared-control systems
With the advent of LSI ICs, the same architecture could be implemented much less expensively than was possible using relays. In addition, it was possible to eliminate the many-wire cabling and replace it with much simpler cable similar to (or even identical to) that used by non-key systems. One of the most recognized such systems is the
Additionally, these more modern systems allowed a vast set of features including:
* Remote supervision of the entire system
* Automatic call accounting
* Speed dialing
* Station-specific limitations (such as no long distance access or no paging)
* Selection of signalling sounds
Features could be added or modified simply using software, allowing easy customization of these systems. The stations were easier to maintain than the previous electromechanical key systems, as they used efficient
LEDs instead of incandescent light bulbs for line status indication.
LSI also allowed smaller systems to distribute the control (and features) into individual telephone sets that don't require any single shared control unit. Generally, these systems are used with a relatively few telephone sets and it is often more difficult to keep the feature set (such as speed-dialing numbers) in synchrony between the various sets.
The line between the largest key systems and full PBX systems is blurred. In the 1A2 days, the line was clear: 1A2 systems did not allow the sharing of anonymous "trunk" lines and PBX systems did. Modern key systems blur this distinction by often allowing this feature.
Hybrid keyphone systems
Into the 21st century, the distinction between key systems and PBX has become increasingly confusing. Early electronic key systems used dedicated handsets which displayed and allowed access to all connected
PSTNlines and stations. , analog handsets (in addition to its own dedicated handsets - usually digital) as well as a raft of features more traditionally found on larger PBX systems. The fact that they support both analog and digital signalling types gives rise to the "Hybrid" designation.
The modern key system is usually fully digital (although analog variants persist) and some systems embrace
VOIP. Indeed, key systems now can be considered to have left their humble roots and become small PBXes. Effectively, the aspects that separate a PBX from a key system are the amount, scope and complexity of the features and facilities offered.
Wikimedia Foundation. 2010.
Look at other dictionaries:
key telephone system — A system that provides direct selection of an outside line from a multiline telephone set; such functions as line holding and intercommunications are selected at the instrument. Visual indications are given on the status of each line… … IT glossary of terms, acronyms and abbreviations
Business telephone system — Early model 464G Western Electric key telephone set A business telephone system is any of a range of a multiline telephone systems typically used in business environments, encompassing systems ranging from small key systems to large scale private … Wikipedia
Key system — can refer to the following:*Key telephone system communication *Key System Defunct transportation system in the San Francisco Bay Area *KeY System a software verification tool. *Cryptosystem using a Cryptographic key … Wikipedia
Telephone plug — A telephone plug is a plug which allows a telephone to connect to the local telephone network. It plugs into a socket or jack fixed to the wall or baseboard. The standard for telephone plugs varies from country to country though the RJ11 has… … Wikipedia
key service unit — (KSU) The main operating unit of a key telephone system … IT glossary of terms, acronyms and abbreviations
telephone — telephoner, n. /tel euh fohn /, n., v., telephoned, telephoning. n. 1. an apparatus, system, or process for transmission of sound or speech to a distant point, esp. by an electric device. v.t. 2. to speak to or summon (a person) by telephone. 3.… … Universalium
Telephone — The telephone (from the el. τῆλε, tēle , far and φωνή, phōnē , voice ) is a telecommunications device that is used to transmit and receive sound (most commonly speech), usually two people conversing but occasionally three or more. It is one of… … Wikipedia
Telephone tapping — Wiretap redirects here. For the radio program, see WireTap (radio program). Telephone tapping (also wire tapping or wiretapping in American English) is the monitoring of telephone and Internet conversations by a third party, often by covert means … Wikipedia
Telephone keypad — A telephone keypad is a keypad that appears on a “Touch Tone” telephone. It was standardised when the dual tone multi frequency (DTMF) system was introduced in the 1960s, and replaced the rotary dial.The contemporary keypad is laid out in a 3… … Wikipedia
Telephone switchboard — PBX switchboard, 1975 A switchboard (also called a manual exchange) was a device used to connect a group of telephones manually to one another or to an outside connection, within and between telephone exchanges or private branch exchanges (PBXs) … Wikipedia