Chord (aircraft)


Chord (aircraft)
Cross section of an airfoil showing chord and chord length
The various chords on the planform of the swept-wing of an aircraft

In aeronautics, chord refers to the imaginary straight line joining the trailing edge and the center of curvature of the leading edge of the cross-section of an airfoil. The chord length is the distance between the trailing edge and the point on the leading edge where the chord intersects the leading edge.[1]

The wing, horizontal stabilizer, vertical stabilizer and propeller of an aircraft are all based on airfoil sections, and the term chord or chord length is also used to describe their width. The chord of a wing, stabilizer and propeller is determined by examining the planform and measuring the distance between leading and trailing edges in the direction of the airflow. (If a wing has a rectangular planform, rather than tapered or swept, then the chord is simply the width of the wing measured in the direction of airflow.) The term chord is also applied to the width of wing flaps, ailerons and rudder on an aircraft.

The term is also applied to airfoils in gas turbine engines such as turbojet, turboprop, or turbofan engines for aircraft propulsion.

Most wings do not have a rectangular planform so they have a different chord at different positions along their span. To give a characteristic figure which can be compared among various wing shapes, the mean aerodynamic chord, or MAC, is used. The MAC is somewhat more complex to calculate, because most wings vary in chord over the span, growing narrower towards the outer tips. This means that more lift is generated on the wider inner portions, and the MAC moves the point to measure the chord to take this into account.

Contents

Standard mean chord

Standard mean chord (SMC) is defined as wing area divided by wing span:[citation needed]

\mbox{SMC} = \frac{S}{b},

where S is the wing area and b is the span of the wing. Thus, the SMC is the chord of a rectangular wing with the same area and span as those of the given wing. This is a purely geometric figure and is rarely used in aerodynamics.

Mean aerodynamic chord

Mean aerodynamic chord (MAC) is defined as:[2]

\mbox{MAC} = \frac{2}{S}\int_{0}^{\frac{b}{2}}c(y)^2 dy ,

where y is the coordinate along the wing span and c is the chord at the coordinate y. Other terms are as for SMC.

Physically, MAC is the chord of a rectangular wing, which has the same area, aerodynamic force and position of the center of pressure at a given angle of attack as the given wing has. Simply stated, MAC is the width of an equivalent rectangular wing in given conditions. Therefore, not only the measure but also the position of MAC is often important. In particular, the position of center of mass (CoM) of an aircraft is usually measured relative to the MAC, as the percentage of the distance from the leading edge of MAC to CoM with respect to MAC itself.

Note that the figure to the right implies that the MAC occurs at a point where leading or trailing edge sweep changes. In general, this is not the case. Any shape other than a simple trapezoid requires evaluation of the above integral.

The ratio of the length (or span) of a wing to its chord is known as the aspect ratio, an important indicator of the lift-induced drag the wing will create. In general, planes with higher aspect ratios — long, skinny wings — will have less induced drag, which dominates at low airspeeds. This is why gliders have long wings.

Tapered wing

Knowing the area (Sw), taper ratio (λ) and the span (b) of the wing, and whether the wing has sweep or not, the chord at any position on the span can be calculated by the formula:[citation needed]

c(y)=\frac{2\,S_w}{(1+\lambda)b}\left[1-\frac{2(1-\lambda)}{b}y\right]

See also

Lift (force)

References

  1. ^ Clancy, L.J. (1975), Aerodynamics, Section 5.2, Pitman Publishing Limited, London. ISBN 0-273-01120-0
  2. ^ Abbott, I.H., and Von Doenhoff, A.E. (1959), Theory of Wing Sections, Section 1.4 (page 27), Dover Publications Inc., New York, Standard Book Number 486-60586-8

External links


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Chord — may refer to: Chord (music), an aggregate of musical pitches sounded simultaneously. Chord (guitar) an aggregate of musical pitches played simultaneously on a guitar Chord (geometry), a line segment joining two points on a curve Chord (astronomy) …   Wikipedia

  • chord — Ⅰ. chord [1] ► NOUN ▪ a group of three or more notes sounded together in harmony. DERIVATIVES chordal adjective. ORIGIN from ACCORD(Cf. ↑accord); the spelling was influenced by CHORD(Cf. ↑chord …   English terms dictionary

  • chord position — The position defined by the location of a quarter chord and the inclination to the aircraft x y plane; a point being defined on primary centerline coordinates. Chord position is described in relation to X and Y axes …   Aviation dictionary

  • Andrew Chord — Chord Publication information Publisher Marvel Comics First a …   Wikipedia

  • Ground effect in aircraft — Aircraft may be affected by a number of ground effects, aerodynamic effects due to a flying body s proximity to the ground.One of the most important of these effects is the Wing In Ground effect, which refers to the reduction in drag experienced… …   Wikipedia

  • General Aircraft GAL.56 — NOTOC The General Aircraft GAL 56 was a British tail less swept wing glider design of the 1940s built by General Aircraft Ltd.There were three GAL 56 of different wing form: *Medium V ( TS507 ) with constant sweep on leading and trailing edges… …   Wikipedia

  • Wide chord — A wide chord fan engine is a term to describe a modern turbofan jet engine having a ducted fan with a specific blade geometry In layman s terms, they would be described as having wider blades than other jet engines.OverviewThe main fan on a jet… …   Wikipedia

  • Royal Aircraft Factory S.E.5 — Role Single seat fighter Manufacturer various (see text) Designer …   Wikipedia

  • Military disc-shaped aircraft — The development of military disc shaped aircraft apparently dates back to World War II. A number of disc shaped aircraft have been proposed over the years, a few being built. Contents 1 Nemeth Umbrella Plane 2 Sack AS.6 3 Vought Flying Flapjack …   Wikipedia

  • Van's Aircraft RV-3 — infobox Aircraft name = RV 3 type = RV 3 manufacturer = Van s Aircraft caption = designer = Richard VanGrunsven first flight = introduction = retired = status = RV 3: Production completed RV 3B: In production primary user = more users = produced …   Wikipedia


We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.