- Equilibrium unfolding
biochemistry, equilibrium unfolding is the process of unfolding a protein or RNA molecule by gradually changing its solution conditions, i.e., its environment. Since equilibrium is maintained at all steps, the process is reversible (equilibrium folding). Equilibrium unfolding is used to determine the conformational stability of the molecule.
In its simplest form, equilibrium unfolding assumes that the molecule may belong to only two thermodynamic states, the "folded state" (typically denoted "N" for "native" state) and the unfolded state (typically denoted "U"). This "all-or-none" model of protein folding was first proposed by Tim Anson (1945), but is believed to hold only for small, single
structural domains of proteins (Jackson, 1998); larger domains and multi-domain proteins often exhibit intermediate states. As usual in statistical mechanics, these states correspond to ensembles of molecular conformations, not just one conformation.
The molecule may transition between the native and unfolded states according to a simple kinetic model
rate constants and for the folding () and unfolding () reactions, respectively. The dimensionless equilibrium constantcan be used to determine the conformational stability by the equation
where is the
gas constantand is the absolute temperature in kelvins. Thus, is positive if the unfolded state is less stable (i.e., disfavored) relative to the native state.
The most direct way to measure the conformational stability of a molecule with two-state folding is to measure its kinetic rate constants and under the solution conditions of interest. However, since protein folding is typically completed in milliseconds, such measurements can be difficult to perform, usually requiring expensive stopped-flow or (more recently)
continuous-flow mixers to provoke folding with a high time resolution.
In the less expensive technique of equilibrium unfolding, the fractions of folded and unfolded molecules (denoted as and , respectively) are measured as the solution conditions are gradually changed from those favoring the native state to those favoring the unfolded state, e.g., by adding a denaturant such as guanidinium hydrochloride or
urea. (In equilibrium folding, the reverse process is carried out.) Given that the fractions must sum to one and their ratio must be given by the Boltzmann factor, we have
Protein stabilities are typically found to vary linearly with the denaturant concentration. A number of models have been proposed to explain this observation prominent among them being the denaturant binding model, solvent-exchange model (both by Schellman, JA [ The thermodynamics of solvent exchange, Biopolymers 34, 1015-1026 (1994) ] ) and the Linear Energy Model (LEM; Pace, NC [Denaturant m values and heat capacity changes: relation to changes in accessible surface areas of protein unfolding, Protein Sci. 4, 2138-2148] ). All of the models assume that only two thermodynamic states are populated/de-populated upon denaturation. They could be extended to interpret more complicated reaction schemes.
The denaturant binding model assumes that there are specific but independent sites on the protein molecule (folded or unfolded) to which the denaturant binds with an effective (average) binding constant "k". The equilibrium shifts towards the unfolded state at high denaturant concentrations as it has more binding sites for the denaturant relative to the folded state (). In other words, the increased number of potential sites exposed in the unfolded state is seen as the reason for denaturation transitions. An elementary treatment results in the following functional form:
where is the stability of the protein in water and [D] is the denaturant concentration. Thus the analysis of denaturation data with this model requires 7 parameters: ,, "k," and the slopes and intercepts of the folded and unfolded state baselines.
The solvent exchange model (also called the ‘weak binding model’ or ‘selective solvation’) of Schellman invokes the idea of an equilibrium between the water molecules bound to independent sites on protein and the denaturant molecules in solution. It has the form:
where is the equilibrium constant for the exchange reaction and is the mole-fraction of the denaturant in solution. This model tries to answer the question of whether the denaturant molecules actually bind to the protein or they "seem" to be bound just because denaturants occupy about 20-30 % of the total solution volume at high concentrations used in experiments, i.e. non-specific effects – and hence the term ‘weak binding’. As in the denaturant-binding model, fitting to this model also requires 7 parameters. One common theme obtained from both these models is that the binding constants (in the molar scale) for urea and guanidinium hydrochloride are small: ~ 0.2 for urea and 0.6 for GuHCl.
Intuitively, the difference in the number of binding sites between the folded and unfolded states is directly proportional to the differences in the accessible surface area. This forms the basis for the LEM which assumes a simple linear dependence of stability on the denaturant concentration. The resulting slope of the plot of stability versus the denaturant concentration is called the m-value. In pure mathematical terms, m-value is the derivative of the change in stabilization free energy upon the addition of denaturant. However, a strong correlation between the accessible surface area (ASA) exposed upon unfolding, i.e. difference in the ASA between the unfolded and folded state of the studied protein (dASA), and the m-value has been documented by Pace and co-workers. In view of this observation, the m-values are typically interpreted as being proportional to the dASA. There is no physical basis for the LEM and is purely empirical, though it is widely used in interpreting solvent-denaturation data. It has the general form:
where the slope is called the "m"-value"(> 0 for the above definition) and (also called "Cm") represents the denaturant concentration at which 50% of the molecules are folded (the "
denaturation midpoint" of the transition, where ).
In practice, the observed experimental data at different denaturant concentrations are fit to a two-state model with this functional form for , together with linear baselines for the folded and unfolded states. The and are two fitting parameters, along with four others for the linear baselines (slope and intercept for each line); in some cases, the slopes are assumed to be zero, giving four fitting parameters in total. The conformational stability can be calculated for any denaturant concentration (including the stability at zero denaturant) from the fitted parameters and . When combined with kinetic data on folding, the "m"-value can be used to roughly estimate the amount of buried hydrophobic surface in the folding transition state.
Unfortunately, the probabilities and cannot be measured directly. Instead, we assay the relative population of folded molecules using various structural probes, e.g.,
absorbanceat 287 nm (which reports on the solvent exposure of tryptophanand tyrosine), far- ultravioletcircular dichroism (180-250 nm, which reports on the secondary structure of the protein backbone) and near-ultraviolet fluorescence(which reports on changes in the environment of tryptophan and tyrosine). However, nearly any probe of folded structure will work; since the measurement is taken at equilibrium, there is no need for high time resolution. Thus, measurements can be made of NMR chemical shifts, intrinsic viscosity, solvent exposure (chemical reactivity) of side chains such as cysteine, backbone exposure to proteases, and various hydrodynamic measurements.
To convert these observations into the probabilities and , one generally assumes that the observable adopts one of two values, or , corresponding to the native or unfolded state, respectively. Hence, the observed value equals the linear sum
By fitting the observations of under various solution conditions to this functional form, one can estimate and , as well as the parameters of . The fitting variables and are sometimes allowed to vary linearly with the solution conditions, e.g., temperature or denaturant concentration, when the
asymptotes of are observed to vary linearly under strongly folding or strongly unfolding conditions.
Assuming a two state denaturation as stated above, one can derive the fundamental thermodynamic parameters namely, , and provided one has knowledge on the of the system under investigation.
The thermodynamic observables of denaturation can be described by the following equations:
where , and indicate the
enthalpy, entropyand Gibbs free energyof unfolding under a constant pH and pressure. The temperature, is varied to probe the thermal stabilityof the system and is the temperature at which half of the molecules in the system are unfolded. The last equation is known as the Gibbs-Helmholtz equation.
Determining the heat capacity of proteins
In principle one can calculate all the above thermodynamic observables above from a single
differential scanning calorimetrythermogram of the system assuming that the is independent of the temperature. However, it is difficult to obtain accurate values for this way. More accurately, the can be derived from a the variations in vs. which can be achieved from measurements with slight variations in or protein concentration. The slope of the linear fit is equal to the . Note that any non-linearity of the datapoints indicates that is probably not independent of the temperature.
Alternatively, the can be estimated very accurately from the calculation of the
accessible solvent area(ASA) of a protein prior and after thermal denaturation as follows:
For proteins that have a known 3d structure, the can be calculated through computer programs such as
Deepview(also known as swiss PDB viewer. The can be calculated from tabulated values of each amino acid through the semi-empirical equation:
where the subscripts polar, non-polar and aromatic indicate the parts of the 20 naturally occurring amino acids.
Finally for proteins there is a linear correlation between and through the following equation [Robertson, A.D., Murphy, K.P. Protein structure and the energetics of protein stability, (1997), "Chem Rev", 97, 1251-1267] :
Assessing two-state unfolding
Furthermore, one can assess whether the folding proceeds according to a two-state unfolding as described above. The can be done with
differential scanning calorimetryby comparing the calorimetric enthalpy of denaturation i.e. the area under the peak, to the van 't Hoff enthalpy described as follows:
at the can be described as:
When a two-state unfolding is observed the .
Other forms of denaturation
Analogous functional forms are possible for denaturation by
pressure, pH, etc.
* Pace CN. (1975) "The Stability of Globular Proteins", "CRC Critical Reviews in Biochemistry", 1-43.
* Santoro MM and Bolen DW. (1988) "Unfolding Free Energy Changes Determined by the Linear Extrapolation Method. 1. Unfolding of Phenylmethanesulfonyl α-Chymotrypsin Using Different Denaturants", "Biochemistry", 27, 8063-8068.
* Privalov PL. (1992) "Physical Basis for the Stability of the Folded Conformations of Proteins", in "Protein Folding", TE Creighton, ed., W. H. Freeman, pp. 83-126.
* Yao M and Bolen DW. (1995) "How Valid Are Denaturant-Induced Unfolding Free Energy Measurements? Level of Conformance to Common Assumptions over an Extended Range of Ribonuclease A Stability", "Biochemistry", 34, 3771-3781.
* Anson ML. (1945) "Protein Denaturation and the Properties of Protein Groups", "Advances in Protein Chemistry", 2, 361-386.
* Jackson SE. (1998) "How do small single-domain proteins fold?", "Folding and Design", 3, R81-R91.
* Schwehm JM and Stites WE. (1998) "Application of Automated Methods for Determination of Protein Conformational Stability", "Methods in Enzymology", 295, 150-170.
Wikimedia Foundation. 2010.
Look at other dictionaries:
Equilibrium — is the condition of a system in which competing influences are balanced and it may refer to:cienceBiology* Equilibrioception, the sense of balance present in humans and animals * Homeostasis, the ability of an open system, especially living… … Wikipedia
Chemical equilibrium — In a chemical reaction, chemical equilibrium is the state in which the concentrations of the reactants and products have not yet changed with time. It occurs only in reversible reactions, and not in irreversible reactions. Usually, this state… … Wikipedia
Dynamic equilibrium — For the economic concept, see Dynamic equilibrium (economics) A dynamic equilibrium exists once a reversible reaction ceases to change its ratio of reactants/products, but substances move between the chemicals at an equal rate, meaning there is… … Wikipedia
Non-equilibrium thermodynamics — Thermodynamics … Wikipedia
Chevron plot — A typical chevron plot observed in protein folding experiments. A chevron plot is a way of representing protein folding kinetic data in the presence of varying concentrations of denaturant that disrupts the protein s native tertiary structure.… … Wikipedia
Phi value analysis — is an experimental protein engineering method used to study the structure of the folding transition state in small protein domains that fold in a two state manner. Since the folding transition state is by definition a transient and partially… … Wikipedia
Protein folding — Protein thermodynamics redirects here. For the thermodynamics of reactions catalyzed by proteins, see Enzyme. Protein before and after folding. Protein folding is the process by which a protein structure assumes its functional shape or… … Wikipedia
Acid dissociation constant — Acetic acid, a weak acid, donates a proton (hydrogen ion, high … Wikipedia
Buffer solution — Acids and Bases Acid dissociation constant Acid base extraction Acid–base reaction Acid–base titration Dissociation constant Acidity function B … Wikipedia
Dissociation constant — Kd redirects here. For other uses, see KD (disambiguation). In chemistry, biochemistry, and pharmacology, a dissociation constant is a specific type of equilibrium constant that measures the propensity of a larger object to separate (dissociate)… … Wikipedia