Strontium titanate


Strontium titanate
Strontium titanate
Identifiers
CAS number 12060-59-2 YesY
PubChem 82899
ChemSpider 74801 YesY
EC number 235-044-1
MeSH Strontium+titanium+oxide
Jmol-3D images Image 1
Image 2
Properties
Molecular formula SrTiO3
Molar mass 183.49 g mol-1
Exact mass 183.838305258 g mol-1
Appearance White, opaque crystals
Density 4.81 g cm-3
Melting point

2060 °C, 2333 K, 3740 °F

Refractive index (nD) 2.41
Structure
Crystal structure Simple cubic
 YesY titanate (verify) (what is: YesY/N?)
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa)
Infobox references

Strontium titanate is an oxide of strontium and titanium with the chemical formula SrTiO3. At room temperature, it is a centrosymmetric paraelectric material with a perovskite structure. At low temperatures it approaches a ferroelectric phase transition with a very large dielectric constant ~104 but remains paraelectric down to the lowest temperatures measured as a result of quantum fluctuations.[1] It was long thought to be a wholly artificial material, until 1982 when its natural counterpart—discovered in Siberia and named tausonite—was recognised by the IMA. Tausonite remains an extremely rare mineral in nature, occurring as very tiny crystals. Its most important application has been in its synthesized form wherein it is occasionally encountered as a diamond simulant, in precision optics, in varistors, and in advanced ceramics.

The name tausonite was given in honour of Lev Vladimirovich Tauson (1917–1989), a Russian geochemist. Disused trade names for the synthetic product include strontium mesotitanate, Fabulite, Diagem, and Marvelite. Other than its type locality of the Murun Massif in the Sakha Republic, natural tausonite is also found in Cerro Sarambi, Concepción department, Paraguay; and along the Kotaki River of Honshū, Japan.[2][3]

Contents

Properties

Atomic resolution image of SrTiO3. Brighter atoms are Sr and darker ones are Ti
Structure of SrTiO3. The red spheres are oxygens, blue are Ti4+ cations, and the green ones are Sr2+.

Strontium titanate is both much denser (specific gravity 4.88 for natural, 5.13 for synthetic) and much softer (Mohs hardness 6–6.5 for natural, 5.5 for synthetic) than diamond. Its crystal system is cubic and its refractive index (2.41—as measured by sodium light, 589.3 nm) is nearly identical to that of diamond, but the dispersion (the optical property responsible for the "fire" of the cut stones) of strontium titanate is over four times higher, at 0.19 (B–G interval). This results in an excess of fire when compared to diamond.[2][3]

Synthetics are usually transparent and colourless, but can be doped with certain rare earth or transition metals to give reds, yellows, browns, and blues. Natural tausonite is usually translucent to opaque, in shades of reddish brown, dark red, or grey. Both have an adamantine (diamond-like) lustre. Strontium titanate is considered extremely brittle with a conchoidal fracture; natural material is cubic or octahedral in habit and streaks brown. Through a hand-held (direct vision) spectroscope, doped synthetics will exhibit a rich absorption spectrum typical of doped stones. Synthetic material has a melting point of ca. 2080°C (3776°F) and is readily attacked by hydrofluoric acid.[2][3]

The synthetic material has a very large dielectric constant (300) at room temperature and low electric field. It is also used in high-voltage capacitors. Strontium titanate becomes superconducting below 0.35 K and was the first insulator and oxide discovered to be superconductive.[4]

At temperatures lower than 105 K, its cubic structure transforms to tetragonal.[5] It is an excellent substrate for epitaxial growth of high-temperature superconductors and many oxide-based thin films. Its monocrystals can be used as optical windows and high-quality sputter deposition targets.

SrTiO3 is a suitable material for electronics: niobium-doped strontium titanate, is electrically conductive. High-quality, epitaxial SrTiO3 layers can also be grown on silicon without forming silicon dioxide, thereby making SrTiO3 an alternative gate dielectric material. This also enables the integration of other thin film perovskite oxides onto silicon.[6]

Synthesis

A plate cut out of synthetic SrTiO3 crystal

Synthetic strontium titanate was one of several titanates patented during the late 1940s and early 1950s; other titanates included barium titanate and calcium titanate. Research was conducted primarily at the National Lead Company (later renamed N. L. Industries, Inc.) in the United States, by Leon Merker and Langtry E. Lynd. Merker and Lynd first patented the growth process on February 10, 1953; a number of refinements were subsequently patented over the next four years, such as modifications to the feed powder and additions of colouring dopants.

A modification to the basic Verneuil process (also known as flame-fusion) is the favoured method of growth. An inverted oxy-hydrogen blowpipe is used, with feed powder mixed with oxygen carefully fed through the blowpipe in the typical fashion, but with the addition of a third pipe to deliver oxygen—creating a tricone burner. The extra oxygen is required for successful formation of strontium titanate, which would otherwise fail to oxidize completely due to the titanium component. The ratio is ca. 1.5 volumes of hydrogen for each volume of oxygen. The highly purified feed powder is derived by first producing titanyl double oxalate salt (SrTiO(C2O4)2·2H2O) by reacting strontium chloride (SrCl2) and oxalic acid ((COOH)2.2H2O) with titanium tetrachloride (TiCl4). The salt is washed to completely eliminate chloride, heated to 1000°C in order to produce a free-flowing granular powder of the required composition, and is then ground and sieved to ensure all particles are between 0.2–0.5 micrometres in size.[7]

The feed powder falls through the oxyhydrogen flame, melts, and lands on a rotating and slowly descending pedestal below. The height of the pedestal is constantly adjusted to keep its top at the optimal position below the flame, and over a number of hours the molten powder cools and crystallises to form a single pedunculated pear or boule crystal. This boule is usually no larger than 2.5 centimetres in diameter and 10 centimetres long; it is an opaque black to begin with, requiring further annealing in an oxidizing atmosphere in order to make the crystal colourless and to relieve strain. This is done at over 1000°C for 12 hours.[7]

Use as a diamond simulant

Its cubic structure and high dispersion once made synthetic strontium titanate a prime candidate for simulating diamond. Beginning ca. 1955, large quantities of strontium titanate were manufactured for this sole purpose. Strontium titanate was in competition with synthetic rutile ("titania") at the time, and had the advantage of lacking the unfortunate yellow tinge and strong birefringence inherent to the latter material. While it was softer, it was significantly closer to diamond in likeness. Eventually, however, both would fall into disuse, being eclipsed by the creation of "better" simulants: first by yttrium aluminium garnet (YAG) and followed shortly after by gadolinium gallium garnet (GGG); and finally by the (to date) ultimate simulant in terms of diamond-likeness and cost-effectiveness, cubic zirconia.[8]

Despite being outmoded, strontium titanate is still manufactured and periodically encountered in jewellery. It is one of the most costly of diamond simulants, and due to its rarity collectors may pay a premium for large i.e. >2 carat (400 mg) specimens. As a diamond simulant, strontium titanate is most deceptive when mingled with melée i.e. <0.20 carat (40 mg) stones and when it is used as the base material for a composite or doublet stone (with, e.g., synthetic corundum as the crown or top of the stone). Under the microscope, gemmologists distinguish strontium titanate from diamond by the former's softness—manifested by surface abrasions—and excess dispersion (to the trained eye), and occasional gas bubbles which are remnants of synthesis. Doublets can be detected by a join line at the girdle ("waist" of the stone) and flattened air bubbles or glue visible within the stone at the point of bonding.[9][10][11]

References

  1. ^ K. A. Muller and H. Burkard (1979). "SrTiO3: An intrinsic quantum paraelectric below 4 K". Phys. Rev. B 19: 3593–3602. doi:10.1103/PhysRevB.19.3593. 
  2. ^ a b c "Tausonite". Webmineral.. http://webmineral.com/data/Tausonite.shtml. Retrieved 2009-06-06. 
  3. ^ a b c "Tausonite". Mindat. http://www.mindat.org/min-3895.html. Retrieved 2009-06-06. 
  4. ^ C. S. Koonce et al. (1967). "Superconducting Transition Temperatures of Semiconducting SrTiO3". Phys. Rev. 163: 380. doi:10.1103/PhysRev.163.380. 
  5. ^ L. Rimai and G. A. deMars (1962). "Electron Paramagnetic Resonance of Trivalent Gadolinium Ions in Strontium and Barium Titanates". Phys. Rev. 127: 702. doi:10.1103/PhysRev.127.702. 
  6. ^ R. A. McKee, F. J. Walker, and M. F. Chisholm (1998). "Crystalline Oxides on Silicon: The First Five Monolayers". Phys. Rev. Lett. 81: 3014. Bibcode 1998PhRvL..81.3014M. doi:10.1103/PhysRevLett.81.3014. 
  7. ^ a b H. J. Scheel and P. Capper (2008). Crystal growth technology: from fundamentals and simulation to large-scale production. Wiley-VCH. p. 431. ISBN 3527317627. 
  8. ^ R. W. Hesse (2007). Jewelrymaking through history: an encyclopedia. Greenwood Publishing Group. p. 73. ISBN 0313335079. 
  9. ^ Nassau, K. (1980). Gems made by man. Santa Monica, California: Gemological Institute of America. pp. 214–221. ISBN 0873110161. 
  10. ^ O'Donoghue, M. (2002). Synthetic, imitation & treated gemstones. Great Britain: Elsevier Butterworth-Heinemann. pp. 34, 65. ISBN 0750631732. 
  11. ^ Read, P. G. (1999). Gemmology, second edition. Great Britain: Butterworth-Heinemann. pp. 173, 176, 177, 293. ISBN 0-7506-4411-7. 

External links


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • strontium titanate — noun : a crystalline compound SrTiO3 used chiefly as an additive to barium titanate ceramic bodies * * * strontium titanate, a crystalline substance almost as brilliant and clear as diamond, made by fusing strontium, titanium, and oxygen, used… …   Useful english dictionary

  • Titanate de strontium — Tausonite Général No CAS …   Wikipédia en Français

  • Strontium — (pronEng|ˈstrɒntiəm, ) is a chemical element with the symbol Sr and the atomic number 38. An alkaline earth metal, strontium is a soft silver white or yellowish metallic element that is highly reactive chemically. The metal turns yellow when… …   Wikipedia

  • STRONTIUM — De Strontian, ville d’Écosse. Symbole chimique: Sr Numéro atomique: 38 Masse atomique: 87,62 Point de fusion: 769 0C Point d’ébullition: 1 384 0C Densité (à 20 0C): 2,54 Métal alcalinoterreux mou, de reflet argenté quand il est fraîchement coupé …   Encyclopédie Universelle

  • Titanate — Als Titanate werden die Salze oder Ester der Titansäuren (HxTiyOz, praktisch die verschiedenen Hydrate von Titandioxid) bezeichnet. Hauptsächlich handelt es sich dabei um die Salze der Orthotitansäure H4TiO4), wobei neben diesen Orthotitanaten… …   Deutsch Wikipedia

  • Strontium 90 — Le strontium 90, noté 90Sr, est l isotope du strontium dont le nombre de masse est égal à 90 : son noyau atomique compte 38 protons et 52 neutrons avec un spin 0+ pour une masse atomique de 89,9077376 g/mol. Il est caractérisé par un… …   Wikipédia en Français

  • Barium titanate — Chembox new Name = Barium titanate ImageFile = ImageName = Barium titanate OtherNames = Section1 = Chembox Identifiers CASNo = 12047 27 7 Section2 = Chembox Properties Formula = BaTiO3 MolarMass = 233.192 g/mol Appearance = white crystals Density …   Wikipedia

  • Lead zirconate titanate — (Lead [Zirconium| x Titanium|1 x ] Oxygen|3 0 …   Wikipedia

  • SrTiO3 — Titanate de strontium Le titanate de strontium est un oxyde de titane et de strontium de formule SrTiO3. Il existe à l état naturel on parle alors de tausonite[1], mais les cristaux habituellement utilisés sont des cristaux de synthèse. Le… …   Wikipédia en Français

  • Tausonite — Titanate de strontium Le titanate de strontium est un oxyde de titane et de strontium de formule SrTiO3. Il existe à l état naturel on parle alors de tausonite[1], mais les cristaux habituellement utilisés sont des cristaux de synthèse. Le… …   Wikipédia en Français


Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.