- Standard electrode potential
In

electrochemistry , the**standard electrode potential**, abbreviated E^{o}, E^{0}, or E^{O}(with a superscriptplimsoll character, pronouncednought ), is the measure of individual potential of a reversible electrode (at equilibrium) atstandard state , which is with solutes at an effective concentration of 1 mol/kg, and gases at a pressure of 1 atmosphere / 100 kPa (Kilopascals)). The values are most often tabularized at 25 °C. The basis for anelectrochemical cell such as thegalvanic cell is always aredox reaction which can be broken down into twohalf-reaction s:oxidation at anode (loss of electron) and reduction at cathode (gain of electron).Electricity is generated due toelectric potential difference between two electrodes. This potential difference is created as a result of the difference between individual potentials of the two metalelectrodes with respect to the electrolyte.Although the overall potential of a cell can be measured, there is no simple way to accurately measure the electrode/electrolyte potentials in isolation. The electric potential also varies with temperature, concentration and pressure. Since the oxidation potential of a half-reaction is the negative of the reduction potential in a redox reaction, it is sufficient to calculate either one of the potentials. Therefore, standard electrode potential is commonly written as standard reduction potential.

**Calculation of standard electrode potentials**The electrode potential may not be obtained empirically. The

galvanic cell potential results from a "pair" of electrodes. Thus, only one empirical value is available in a pair of electrodes and it is not possible to determine the value for each electrode in the pair using the empirically obtained galvanic cell potential. A reference electrode, thestandard hydrogen electrode (SHE), for which the potential is "defined" or agreed upon by convention, needed to be established. In this case SHE is set to 0.00 V and any electrode, for which the electrode potential is not yet known, can be paired with SHE -to form a galvanic cell- and the galvanic cell potential gives the unknown electrode's potential. Using this process, any electrode with an unknown potential can be paired with either the SHE or another electrode for which the potential has already been derived and that unknown value can be established.Since the electrode potentials are conventionally defined as reduction potentials, the sign of the potential for the metal electrode being oxidized must be reversed when calculating the overall cell potential. Note that the electrode potentials are independent of the number of electrons transferred -that is, they are set to one mole of electrons transferred- and so the two electrode potentials can be simply combined to give the overall "cell" potential even if different numbers of electrons are involved in the two electrode reactions

Since the

table of standard electrode potentials is defined for a transfer of one mole of electrons, care must be made in determining an electrode potential using two other electrode potentials. Adjustments have to be made for the number of electrons being transferred.For example:

(eq1) Fe

^{3+}+ 3e^{-}--> Fe(s) is listed as -0.036 V(eq2) Fe

^{2+}+ 2e^{-}--> Fe(s) is listed as -0.44 Vto get a third equation:

(eq3) Fe

^{3+}+ e^{-}--> Fe^{2+}(listed as +0.77 V)one would need to take eq1 and multiply the voltage by 3, reverse eq2 (changes the sign) and multiply the voltage by 2. Adding those two voltages together gives the standard potential for eq3.

**Standard reduction potential table**Since the values are given in their ability to be reduced, the bigger the standard reduction potentials, the easier they are to be reduced, in other words, they are simply better oxidizing agents. For example, F

_{2}has 2.87 V and Li^{+}has -3.05 V. F_{2}reduces easily and is therefore a good oxidizing agent. In contrast, Li_{(s)}would rather undergo oxidation (hence a goodreducing agent ). Thus Zn^{2+}whose standard reduction potential is -0.76 V can beoxidized by any other electrode whose standard reduction potential is greater than -0.76 V (eg. H^{+}(0 V), Cu^{2+}(0.16 V), F_{2}(2.87 V)) and can bereduced by any electrode with standard reduction potential less than -0.76 V (eg. H_{2}(-2.23 V), Na^{+}(-2.71 V), Li^{+}(-3.05 V)).In a galvanic cell, where a

spontaneous redox reaction drives the cell to produce an electric potential,Gibbs free energy ΔG^{o}must be negative, in accordance with the following equation::

**ΔG**where "n" is number of moles of electrons per mole of products and "F" is the^{o}_{cell}= -nFE^{o}_{cell}Faraday constant , ~96485 C/mol. As such, the following rules apply::If E

^{o}_{cell}> 0, then the process is spontaneous (galvanic cell ):If E

^{o}_{cell}< 0, then the process is nonspontaneous (electrolytic cell )Thus in order to have a spontaneous reaction (-ΔG

^{o}), E^{o}_{cell}must be positive, where::

**E**^{o}_{cell}= E^{o}_{anode}+ E^{o}_{cathode}where E

^{o}_{anode}is the standard potential at the anode (reverse the sign of the standard reduction potential value for the electrode)and E^{o}_{cathode}is the standard potential at the cathode as given in the table of standard electrode potential.**Non-standard condition**The standard electrode potentials are given at standard conditions. However, real cells may operate under non-standard conditions. Given the standard potential of the half-cell, its potential at non-standard effective concentrations can be calculated using the

Nernst equation :$E\_\{\; ext\{half-cell\; =\; E^0\; -\; frac\{RT\}\{nF\}lnfrac\{\{\; ext\{red\}\{\{\; ext\{oxd\}$

The values of E

^{0}depend on temperature (except for SHE, for which the potential has been, arbitrarily, declared 0 at all temperatures) and are normally referenced to the SHE at the same temperature. For condensed phases, they are also expected to depend somewhat on pressure (see the article on equilibrium constant). For example, the standard electrode potential for Ni/NiO redox couple has been well studied because such a solid has applications in high-temperature pseudo-reference electrodes (when enclosed inside an yttrium-stabilized zirconia ceramic membrane). The standard potential of Ni/NiO has been correlated for temperatures between 0 and 400 °C to be approximately [*R.W. Bosch, D.Feron, and J.P. Celis, "Electrochemistry in Light Water Reactors", CRC Press, 2007.*] ::E

^{0}(T) = -0.0003 T + 0.1414where E

^{0}is in volts, and T is in degrees Celsius.In

biochemistry , potentials are usually defined for pH 7, with the standard potential under these conditions being "E"^{o'}- also referred to as the "mid-point potential" or "E"_{m,7}because it is the potential at which the concentrations of the oxidised and reduced forms of the redox pair are equal.The actual redox potential for a pair at a given pH of x ("E"

_{h, pH = x}) is related to the midpoint potential by:$E\_\{h,pH=x\}\; =\; E\_\{m,pH=x\}\; -\; frac\{2.3RT\}\{nF\}log\_\{10\}frac\{\; [\; ext\{red\}]\; \}\{\; [\; ext\{oxd\}]\; \}$

**ee also***

Reference electrode

*Table of standard electrode potentials

*Reduction potential

*Absolute electrode potential

*Electrochemical potential

*Redox

*Galvanic series

*Nernst equation

*Half cell

*Electrochemical cell

*Galvanic cell

*Concentration cell **Further reading***Zumdahl, Steven S., Zumdahl, Susan A (2000) "Chemistry" (5th ed.), Houghton Mifflin Company. ISBN 0-395-98583-8

*Atkins, Peter, Jones, Loretta (2005) "Chemical Principles" (3rd ed.), W.H. Freeman and Company. ISBN 0-7167-5701-X

*Zu, Y, Couture, MM, Kolling, DR, Crofts, AR, Eltis, LD, Fee, JA, Hirst, J (2003) "Biochemistry", 42, 12400-12408

*Shuttleworth, SJ (1820) "Electrochemistry" (50th ed.), Harper Collins.**External links*** [

*http://www.physchem.co.za/Data/Electrode%20Potentials.htm Standard Hydrogen Potential*]

* [*http://www.chemguide.co.uk/physical/redoxeqia/introduction.html Redox Equilibria*]

* [*http://www.science.uwaterloo.ca/~cchieh/cact/c123/battery.html Chemistry of Batteries*]

* [*http://hyperphysics.phy-astr.gsu.edu/HBASE/Chemical/electrochem.html#c1 Electrochemical Cells*]**References**

*Wikimedia Foundation.
2010.*

### Look at other dictionaries:

**Standard electrode potential**— Standard electrode potential. См. Стандартный электродный потенциал. (Источник: «Металлы и сплавы. Справочник.» Под редакцией Ю.П. Солнцева; НПО Профессионал , НПО Мир и семья ; Санкт Петербург, 2003 г.) … Словарь металлургических терминов**standard electrode potential**— standartinis elektrodo potencialas statusas T sritis chemija apibrėžtis Potencialų skirtumas, susidarantis metalui arba nemetalui liečiantis su tirpalu, kurio elektrochemiškai veiklių jonų koncentracija 1 mol/l. atitikmenys: angl. standard… … Chemijos terminų aiškinamasis žodynas**standard electrode potential**— standard reduction potential the electrochemical potential developed by a half cell under standard conditions (1 atm pressure; specified temperature, usually 25°C; substances in solution at 1 M concentration) compared to the potential of the… … Medical dictionary**standard electrode potential**— noun an electrode potential measured under standard conditions; a temperature or 298K, 1 atmosphere pressure and at 1 mole of the activity of redox participants of the half reaction … Wiktionary**Standard electrode potential (data page)**— The standard electrode potentials are electrode potentials of half cells at equilibrium. They can be used to determine the potential of an electrochemical cell or galvanic cell, or a position of equilibrium for an electrochemical (redox) reaction … Wikipedia**E ° standard electrode potential average beta energy**— baseline effect; electric affinity … Medical dictionary**electrode potential**— noun the potential difference of a half reaction which occurs across a reversible cell made up of any electrode and a standard hydrogen electrode … Wiktionary**Absolute electrode potential**— Absolute electrode potential, in electrochemistry, according to an IUPAC definition [ [http://goldbook.iupac.org/A00022.html IUPAC Gold Book absolute electrode potential ] ] , is the electrode potential of a metal measured with respect to a… … Wikipedia**Standard hydrogen electrode**— NHE redirects here. For the sodium hydrogen exchanger protein, see Sodium hydrogen antiporter. The standard hydrogen electrode (abbreviated SHE), is a redox electrode which forms the basis of the thermodynamic scale of oxidation reduction… … Wikipedia**electrode**— noun /əˈlɛk.trəʊd,iˈlɛk.trəʊd/ a) the terminal through which electric current passes between metallic and nonmetallic parts of an electric circuit b) a collector or emitter of electric ch … Wiktionary