Eaton Hall Railway


Eaton Hall Railway

Infobox rail
railroad_name=Eaton Hall Railway
gauge= RailGauge|15
start_year=1896
end_year=1946
length=4frac|1|2 miles
hq_city=Eaton Hall
locale=England
The Eaton Hall Railway was an early RailGauge|15 gauge narrow gauge estate railway built in 1896 at Eaton Hall in Cheshire.

It was built for the Duke of Westminster by Sir Arthur Percival Heywood, who had pioneered the fifteen inch (381 mm) gauge with his Duffield Bank Railway, and connected the hall to the GWR station sidings at Balderton on their Shrewsbury to Chester Line, some three miles (5 km) away.

Laying the line

The total length of the line was four and a half miles, with the addition of several branches including one long one to the brick store and estate workshop at Cuckoo's Nest.

The track was steel flat-bottomed rail of 16 1/2 lb per yard, attached by spring clips to steel sleepers, three feet long and six and a half inches wide, spaced at convert|2|ft|3|in|m|sing=on centres. Pointwork was prepared at the workshop in Duffield (for which Heywood charged £7/15s/0d [£7.75] each), and carried to site. The maximum gradient was 1 in 70, Eaton Hall being convert|51|ft|m above the sidings at Balderton.

For much of its length it followed the main driveway and crossed the park, including the major driveways. Therefore the line had to be as unobtrusive as possible and was laid level with the ground with a central drainage pipe beneath. The ballast was red furnace cinder, five to six inches (152 mm) deep and four feet wide. On leaving the park the line was embanked. The line was not fenced - where it crossed between fields it was carried on girders over a deep ditch to prevent cattle straying.

There were bridges over one or two streams, the longest being convert|28|ft|m, but it crossed roadways on the level, at one point the main Wrexham to Chester road. Although Heywood had obtained wayleave , it could only be a temporary arrangement, since, for a private railway, the council was not able to enter in an agreement which bound its successors. Heywood therefore campaigned for a clause in the proposed Light Railway Bill which would allow permission for public road crossings to be granted in perpetuity.

Rolling stock

The first engine was "Katie", an 0-4-0T with Brown/Heywood valvegear (it had originally been intended to fit Stephenson/Howe valvegear). Following this were two identical 0-6-0T locomotives, "Shelagh" and "Ursula". Further details are given below. Katie proved capable of handling up to 40 tons on the level, or 20 tons on the gradient, at a speed of around convert|10|mi/h|km/h|abbr=on. Under test, twenty mph was achieved in safety.

All rolling stock was built to negotiate curves of twenty five foot minimum radius. Self-acting coupler-buffers were fitted and measures were taken to ensure interchangeability of parts.

Thirty open waggons and a 4 wheeled brake van were initially provided each wagon carrying about 16 cwt of coal or 22 cwt of bricks. The wagon 'tops' were removable to allow them to be used as flats, and bolster fittings were supplied to carry long items such as timber. An open 16 seat bogie coach, a bogie parcel van (for 'game') and a small open 4 wheeled brake 'van' were also provided at the opening. Finally, a closed bogie passenger vehicle some twenty feet long seating 12 people inside and four outside and a bogie brakevan seating four inside and four outside were supplied after opening. Other wagons were constructed by the Eaton Estate and rebuilt over the years.

Operation

The design estimate for the line was around 5,000 tons per year, mainly coal, timber, road metal and bricks. To Heywood's mind it was the ideal application for this gauge of railway.

The Eaton Hall railway closed in 1946 and was lifted in 1947 .

A new convert|15|in|mm|sing=on railway, named the Eaton Park Railway was built in 1994 with a replica of "Katie". It is not available for use by the public except on the various garden open days. The new line consists of a large loop with a spur leading to the engine shed. The latter follows a small part of the original route.

The original Katie was sold to the newly-built Ravenglass and Eskdale Railway and then in 1922 to the Llewellyn Miniature Railway in Southport. In 1923 she was sold to the Fairbourne Miniature Railway where she operated trains until scrapping in 1926. Parts of the original are currently back at Ravenglass being rebuilt using the original frames and various parts from other Heywood locomotives, while a replica is being constructed by the Perrygrove Railway in Gloucestershire which was built with Sir Arthur's work very much in mind.

Locomotives

: 1896 Katie 0-4-0T boiler 160 psi, grate area convert|2.12|sqft|m2|abbr=on., heating surface convert|53|sqft|m2|abbr=on., cylinders 4.675"x7", wheel diameter 1'3", Brown/Heywood valvegear.: 1904 Shelagh 0-6-0T boiler 160 psi, grate area convert|3|sqft|m2|abbr=on., heating surface convert|80|sqft|m2|abbr=on., cylinders 5.5"x8", wheel diameter 1'4", Brown/Heywood valvegear.: 1916 Ursula 0-6-0T as Shelagh

References

* Clayton, H. (1968) "The Duffield Bank and Eaton Railways", The Oakwood Press, X19, ISBN 0-85361-034-7
* Heywood, A.P. (1898) "Minimum Gauge Railways", 3rd Ed., Derby: Bemrose. Republished (1974) by Turntable Enterprises, ISBN 0-902844-26-1
* Smithers, Mark (1995) "Sir Arthur Heywood and the Fifteen Inch (381 mm) Gauge Railway", Plateway Press, ISBN 1-871980-22-4.

External links

* [http://www.geoffspages.co.uk/raildiary/eatonpark/index.htm A visit to the Eaton Hall Railway]
* [http://www.dself.dsl.pipex.com/MUSEUM/LOCOLOCO/heywood/heywood.htm The Heywood Radiating Axle Locomotives.]
* [http://www.perrygrove.co.uk/heywood-collection.html The Heywood Collection - Conserving the work of Sir A. P. Heywood Bt.]


Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Eaton Hall (Cheshire) — Eaton Hall is a country house set within a large park in the village of Eccleston near Chester in England. It is the country house of the Duke of Westminster. The estate covers 11,000 acres (45 km²). The estate has belonged to the Grosvenor… …   Wikipedia

  • Eaton, Leicestershire — Eaton is a village in Leicestershire, England. It is situated in the picturesque vale of Belvoir and its current population is about 900 people. Eaton has a church, a village hall, a pub (the castle), a children s park being built and a new… …   Wikipedia

  • Duffield Bank Railway — Locale England Dates of operation 1874–1916 Track gauge …   Wikipedia

  • Ridable miniature railway — Locomotive from the Chemin de fer Touristique d Anse, France …   Wikipedia

  • Ravenglass and Eskdale Railway locomotives — River Mite at Dalegarth This article gives details of the locomotives used on the Ravenglass and Eskdale Railway, a 15 inches (380 mm) narrow gauge preserved railway line running for 7 miles (11 km) from Ravenglass on the Cumbrian coast …   Wikipedia

  • Minimum gauge railway — Track gauge by size Broad gauge Sta …   Wikipedia

  • Perrygrove Railway — The Perrygrove Railway is a minimum gauge railway running on RailGauge|15 gauge track. It is a private heritage railway running at Perrygrove Farm in the Royal Forest of Dean near Coleford, Gloucestershire, England. Trains travel at frequent… …   Wikipedia

  • Romney, Hythe and Dymchurch Railway — Romney, Hythe Dymchurch Railway Northern Chief at New Romney Overview Type Light railway Locale Ken …   Wikipedia

  • Conwy Valley Railway Museum — The miniature steam railway The buf …   Wikipedia

  • Markeaton Park Light Railway — Markeaton Lady, Light Railway Locomotive Locale Markeaton Park, Derbyshire …   Wikipedia