Processor register


Processor register

In computer architecture, a processor register is a small amount of storage available as part of a CPU or other digital processor. Such registers are (typically) addressed by mechanisms other than main memory and can be accessed more quickly. Almost all computers, load-store architecture or not, load data from a larger memory into registers where it is used for arithmetic, manipulated, or tested, by some machine instruction. Manipulated data is then often stored back in main memory, either by the same instruction or a subsequent one. Modern processors use either static RAM or dynamic RAM as main memory, the latter often being implicitly accessed via one or more cache-levels. A common property of computer programs is locality of reference: the same values are often accessed repeatedly and frequently used values held in registers improves performance. This is what makes fast registers (and caches) meaningful.

Processor registers are normally at the top of the memory hierarchy, and provide the fastest way to access data. The term normally refers only to the group of registers that are directly encoded as part of an instruction, as defined by the instruction set. However, modern high performance CPUs often have duplicates of these "architectural registers" in order to improve performance via register renaming, allowing parallel and speculative execution. Modern x86 is perhaps the most well known example of this technique.[1]

Allocating frequently used variables to registers can be critical to a program's performance. This register allocation is either performed by a compiler, in the code generation phase, or manually, by an assembly language programmer.

Contents

Categories of registers

Registers are normally measured by the number of bits they can hold, for example, an "8-bit register" or a "32-bit register". A processor often contains several kinds of registers, that can be classified accordingly to their content or instructions that operate on them:

  • User-accessible Registers - The most common division of user-accessible registers is into data registers and address registers.
  • Data registers are used to hold numeric values such as integer and floating-point values. In some older and low end CPUs, a special data register, known as the accumulator, is used implicitly for many operations.
  • Address registers hold addresses and are used by instructions that indirectly access memory.
    • Some processors contain registers that may only be used to hold an address or only to hold numeric values (in some cases used as an index register whose value is added as an offset from some address); others allow registers to hold either kind of quantity. A wide variety of possible addressing modes, used to specify the effective address of an operand, exist.
    • A stack pointer, sometimes called a stack register, is the name given to a register that can be used by some instructions to maintain a stack.
  • Conditional registers hold truth values often used to determine whether some instruction should or should not be executed.
  • General purpose registers (GPRs) can store both data and addresses, i.e., they are combined Data/Address registers.
  • Floating point registers (FPRs) store floating point numbers in many architectures.
  • Constant registers hold read-only values such as zero, one, or pi.
  • Vector registers hold data for vector processing done by SIMD instructions (Single Instruction, Multiple Data).
  • Special purpose registers ( SPR ) hold program state; they usually include the program counter (aka instruction pointer), stack pointer, and status register (aka processor status word). In embedded microprocessors, they can also correspond to specialized hardware elements.
  • In some architectures, model-specific registers (also called machine-specific registers) store data and settings related to the processor itself. Because their meanings are attached to the design of a specific processor, they cannot be expected to remain standard between processor generations.
  • Control and status registers - It has three types: program counter, instruction registers and program status word (PSW).
  • Registers related to fetching information from RAM, a collection of storage registers located on separate chips from the CPU (unlike most of the above, these are generally not architectural registers):

Hardware registers are similar, but occur outside CPUs.

Some examples

Architecture Integer
registers
FP
registers
x86 8 8
x86-64 16 16
IBM/360 16 4
Z/Architecture 16 16
Itanium 128 128
UltraSPARC 32 32
IBM POWER 32 32
Alpha 32 32
6502 3 0
PIC microcontroller 1 0
AVR microcontroller 32 0
ARM 16 16

The table shows the number of registers of several mainstream architectures. Note that the stack pointer (ESP) is counted as an integer register on x86-compatible processors, even though there are a limited number of instructions that may be used to operate on its contents. Similar caveats apply to most architectures. x86 FPUs have 8 80-bit stack levels in legacy mode, and at least 8 128-bit XMM registers in SSE modes.

Although all of the shown architectures are different, 95% of the computer architectures are based on a basic architecture known as Von Neumann architecture proposed by Von Neumann.

Register usage

The number of registers available on a processor and the operations that can be performed using those registers has a significant impact on the efficiency of code generated by optimizing compilers. The Strahler number defines the minimum number of registers required to evaluate an expression tree.

See also

Notes and references

  1. ^ Since around 1995 and the Pentium Pro, Cyrix 6x86, Nx586, and AMD K5.

Wikimedia Foundation. 2010.

Look at other dictionaries:

  • processor register — procesoriaus registras statusas T sritis informatika apibrėžtis Procesoriuje esanti ir jam priklausanti vieno kompiuterio žodžio talpos labai sparti atmintis. Paskirtis įvairi. Centrinis procesorius paprastai turi komandų registrą, keletą… …   Enciklopedinis kompiuterijos žodynas

  • Register — may refer to:In linguistics: * Register and contour tones, a linguistics term for tones distinguished by relative pitch * Register (sociolinguistics), a form of a language used for a particular purpose or social setting * Register (phonology), a… …   Wikipedia

  • Register file — A register file is an array of processor registers in a central processing unit (CPU). Modern integrated circuit based register files are usually implemented by way of fast static RAMs with multiple ports. Such RAMs are distinguished by having… …   Wikipedia

  • Register renaming — In computer engineering, register renaming refers to a technique usedto avoid unnecessary serialization of program operations imposed by the reuseof registers by those operations.Problem definitionPrograms are composed of instructions which… …   Wikipedia

  • Register transfer language — In computer science, register transfer language (RTL) is a term used to describe a kind of intermediate representation (IR) that is very close to assembly language, such as that which is used in a compiler. Academic papers and textbooks also… …   Wikipedia

  • Register allocation — In compiler optimization, register allocation is the process of multiplexing a large number of target program variables onto a small number of CPU registers. The goal is to keep as many operands as possible in registers to maximise the execution… …   Wikipedia

  • Register (Computer) — Als Register bezeichnet man in der Digital oder Computertechnik Speicherbereiche, die innerhalb eines Prozessors direkt mit der eigentlichen Recheneinheit verbunden sind und die unmittelbaren Operanden und Ergebnisse aller Berechnungen aufnehmen …   Deutsch Wikipedia

  • Register Alias Table — In a computer processor, a register alias table is a unit that maps architectural registers to physical registers. See also Register renaming …   Wikipedia

  • Processor Status Word — Das Statusregister (auch Zustandsregister, engl. Condition Code Register, CCR) ist ein spezielles Register im Steuerwerk eines Mikroprozessors. Da man diese Bits auch als Flags bezeichnet, wird das Statusregister auch Flagregister genannt. Es… …   Deutsch Wikipedia

  • Processor Local Bus — Le Processor Local Bus (PLB) est un bus introduit[Quand ?] par IBM dans le cadre de l architecture de bus CoreConnect, qui comprend également les bus OPB (On chip Peripheral Bus) et DCR (Device Control Register). Caractéristiques du bus… …   Wikipédia en Français


Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”

We are using cookies for the best presentation of our site. Continuing to use this site, you agree with this.