Active laser medium

Active laser medium

The active laser medium or gain medium is the source of optical gain within a laser. The gain results from the stimulated emission of electronic or molecular transitions to a lower energy state from a higher energy statepreviously populated by a pump source.

Examples of active laser media include:
*Certain crystals, typically doped with rare-earth ions (e.g. neodymium, ytterbium, or erbium) or transition metal ions (titanium or chromium); most often yttrium aluminium garnet (YAG), yttrium orthovanadate (YVO4), or sapphire (Al2O3); [Hecht, Jeff. "The Laser Guidebook: Second Edition." McGraw-Hill, 1992. (Chapter 22)]
*Glasses, e.g. silicate or phosphate glasses, doped with laser-active ions; [Hecht, Chapter 22]
*Gases, e.g. mixtures of helium and neon (HeNe), nitrogen, argon, carbon monoxide, carbon dioxide, or metal vapors; [Hecht, Chapters 7-15]
*Semiconductors, e.g. gallium arsenide (GaAs), indium gallium arsenide (InGaAs), or gallium nitride (GaN); [Hecht, Chapters 18-21]

In order to lase, the active gain medium must be in a nonthermal energy distribution known as a population inversion. The preparation of this state requires an external energy source and is known as laser pumping. Pumping may be achieved with electrical currents (e.g. semiconductors, or gases via high-voltage discharges) or with light, generated by discharge lamps or by other lasers (semiconductor lasers). More exotic gain media can be pumped by chemical reactions, nuclear fission, or with high-energy electron beams. [ Encyclopedia of laser physics and technology] ] .

Example of a model of gain medium

A universal model valid for all laser types does not exist.cite book
publisher=University Science Books
id= ISBN 0-935702-11-3
] The simplest model includes two systems of sub-levels: upper and lower. Within each level, the fast transitions lead to the Boltzmann distribution of excitations among sub-levels "(fig.1)". The upper level is assumed to be metastable,neither gain nor refractive index depend on a particular way of excitation.

For good performance of the gain medium, the separation between sub-levels should be larger than working temperature; then, at pump frequency ~omega_{ m p}~, the absorption dominates.

In the case of amplification of optical signals, the lasing frequency is called "signal frequency." However, the same term is used even in the laser oscillators, when amplified radiation is used to transfer energy rather than information. The model below seems to work well for most optically-pumped solid-state lasers.


The simple medium can be characterized with effective cross-sections of absorption and emission at frequencies ~omega_{ m p}~ and ~omega_{ m s}~.
*Let ~N~ be concentration of active centers in the solid-state lasers.
*Let ~N_1~ be concentration of active centers in the ground state.
*Let ~N_2~ be concentration of excited centers.
*Let ~N_1+N_2=N~.

The relative concentrations can be defined as ~n_1=N_1/N~ and ~n_2=N_2/N~.

The rate of transitions of an active center from ground state to the excited state can be expressed with ~ W_{ m u}=frac{I_{ m p}sigma_{ m ap{ hbar omega_{ m p} }+frac{I_{ m s}sigma_{ m as{ hbar omega_{ m s} } ~ andThe rate of transitions back to the ground state can be expressed with ~W_{ m d}=frac{ I_{ m p} sigma_{ m as{ hbar omega_{ m p} }+frac{I_{ m s}sigma_{ m es{ hbar omega_{ m s} } +frac{1}{ au}~,where ~sigma_{ m as} ~ and ~sigma_{ m ap} ~ are effective cross-sections of absorption at the frequencies of the pump and the signal.

~sigma_{ m es} ~ and ~sigma_{ m ep} ~ are the same for stimulated emission;

~frac{1}{ au}~ is rate of the spontaneous decay of the upper level.

Then, the kinetic equation for relative populations can be written as follows: ~ frac m d}n_2} m d}t}=W_{ m u} n_1 -W_{ m d} n_2~,

~ frac m d}n_1} m d}t}=-W_{ m u} n_1 + W_{ m d} n_2~However, these equations keep ~ n_1+n_2=1 ~.

The absorption ~ A ~ at the pump frequency and the gain ~ G ~ at the signal frequency can be written as follows:~ A = N_1sigma_{ m pa} -N_2sigma_{ m pe} ~,~ G = N_2sigma_{ m se} -N_1sigma_{ m se} ~.

teady-state solution

In many cases the gain medium works in a continuous-wave or quasi-continuous regime, causing the time derivatives of populations to be negligible.

The steady-state solution can be written: ~ n_2=frac{W_{ m u{W_{ m u}+W_{ m d ~~ n_1=frac{W_{ m d{W_{ m u}+W_{ m d ~

The dynamic saturation intensities can be defined:~ I_{ m po}=frac{hbar omega_{ m p{(sigma_{ m ap}+sigma_{ m ep}) au} ~,~ I_{ m so}=frac{hbar omega_{ m s{(sigma_{ m as}+sigma_{ m es}) au} ~.

The absorption at strong signal:~ A_0=frac{ND}{sigma_{ m as}+sigma_{ m es~.

The gain at strong pump:~ G_0=frac{ND}{sigma_{ m ap}+sigma_{ m ep~,where ~ D=sigma_{ m pa}sigma_{ m se}-sigma_{ m pe}sigma_{ m sa}~is determinant of cross-section.

Gain never exceeds value ~G_0~, and absorption never exceeds value ~A_0~.

At given intensities ~I_{ m p}~, ~I_{ m s}~ of pump and signal, the gain and absorptioncan be expressed as follows:~A=A_0frac{U+s}{1+p+s}~,~G=G_0frac{p-V}{1+p+s}~,

where ~p=I_{ m p}/I_{ m po}~ ,~s=I_{ m s}/I_{ m so}~ ,~U=frac{(sigma_{ m as}+sigma_{ m es})sigma_{ m ap{D}~ ,~V=frac{(sigma_{ m ap}+sigma_{ m ep})sigma_{ m as{D}~ .


The following identities cite journal
coauthors=J.F.Bisson, K.Takaichi, K.Ueda
title=Single-mode solid-state laser with short wide unstable cavity
journal=JOSAB|volume=22| issue=8| pages=1605–1619
] take place:

~U-V=1~,~A/A_0 +G/G_0=1~.

The state of gain medium can be characterized with a single parameter, such as population of the upper level, gain or absorption.

Efficiency of the gain medium

The efficiency of a gain medium can be defined as~ E =frac{I_{ m s} G}{I_{ m p}A}~.

Within the same model, the efficiency can be expressed as follows:~E =frac{omega_{ m s{omega_{ m p frac{1-V/p}{1+U/s}~.

For the efficient operation both intensities, pump and signal should exceed their saturation intensities;~frac{p}{V}gg 1~, and ~frac{s}{U}gg 1~.

The estimates above are valid for a medium uniformly filled with pump and signal light. The spatial hole burning may slightly reduce the efficiency because some regions are pumped well, but the pump is not efficiently withdrawn by the signal in the nodes ofthe interference of counter-propagating waves.

ee also

*Population inversion,
*Laser construction,
*Laser science,
*List of laser types

References and notes

Wikimedia Foundation. 2010.

Look at other dictionaries:

  • Laser — For other uses, see Laser (disambiguation). United States Air Force laser experiment …   Wikipedia

  • Laser-guided bomb — A laser guided bomb (LGB) is a precision guided munition (PGM) that uses semi active laser homing to strike a designated target with greater accuracy than a free fall bomb. LGBs are one of the most common and widespread PGMs, used by a large… …   Wikipedia

  • Laser (debit card) — Laser is the primary debit card system used in Ireland. Laser was launched in 1996 and currently has around 2.5 million customers. Seven Irish financial institutions are partners in the Laser card system: Allied Irish Banks, Bank of Ireland, EBS… …   Wikipedia

  • Laser TV — is a new video display technology using laser optoelectronics.HistoryProposed as long ago as 1966 [cite web url= title=2006 Laser Projection Systems Report publisher=… …   Wikipedia

  • Laser beam profiler — A laser beam profiler captures, displays, and records the spatial intensity profile of a laser beam at a particular plane transverse to the beam propagation path. Since there are many types of lasers ultraviolet, visible, infrared, continuous… …   Wikipedia

  • Laser diode — Top: a packaged laser diode shown with a penny for scale. Bottom: the laser diode chip is removed from the above package and placed on the eye of a needle for scale …   Wikipedia

  • Active protection system — An active protection system, or APS, protects a tank or other armoured fighting vehicle from incoming fire before it hits the vehicle s armour. There are two general categories: soft kill systems, which use jamming or decoys to confuse a missile… …   Wikipedia

  • laser active medium — aktyvioji lazerio terpė statusas T sritis radioelektronika atitikmenys: angl. laser active medium vok. Lasermedium, n rus. лазерная активная среда, f pranc. milieu actif laser, m …   Radioelektronikos terminų žodynas

  • laser à liquide avec circulation d'un milieu actif — cirkuliuojančio aktyviojo skysčio lazeris statusas T sritis radioelektronika atitikmenys: angl. circulating active liquid laser vok. Flüssigkeitslaser mit strömendem aktivem Medium, m rus. жидкостный лазер с циркуляцией активной среды, m pranc.… …   Radioelektronikos terminų žodynas

  • laser diode — noun A laser whose active medium is a form of light emitting diode …   Wiktionary