Magneto-optical trap

experimental setup of the MOT

A magneto-optical trap (abbreviated MOT) is a device that uses both laser cooling with magneto-optical trapping in order to produce samples of cold, trapped, neutral atoms at temperatures as low as several microkelvins, two or three times the recoil limit. By combining the small momentum of a single photon with a velocity and spatially dependent absorption cross section and a large number of absorption-spontaneous emission cycles, atoms with initial velocities of hundreds of metres per second can be slowed to tens of centimetres per second.

Although charged particles can be trapped using a Penning trap or a Paul trap using a combination of electric and magnetic fields, these traps do not work for neutral atoms.

Doppler cooling

Main article: Doppler cooling

Photons have a momentum given by ħk (where ħ is the reduced Planck constant and k the photon wavenumber), which is conserved in all atom-photon interactions. Thus, when an atom absorbs a photon, it is given a momentum kick in the direction of the photon before absorption. By detuning a laser beam to a frequency less than the resonant frequency (also known as red detuning), laser light is only absorbed if the light is frequency up-shifted by the Doppler effect; which occurs whenever the atom is moving towards the laser source. This applies a friction force to the atom whenever it moves towards a laser source.

For cooling to occur along in all directions, the atom must see this friction force along all 3 cartesian axis; this is most easily achieved by illuminating the atom with 3 orthogonal laser beams, which are then reflected back along the same direction.

Magnetic trapping

Magnetic trapping is created by adding a spatially varying magnetic quadrupole field to the red detuned optical field needed for laser cooling. This causes a Zeeman shift in the magnetic-sensitive m_f levels, which increases with the radial distance from the centre of the trap. Because of this, as an atom moves away from the centre of the trap, the atomic resonance is shifted closer to the frequency of the laser light, and the atom becomes more likely to get a photon kick towards the centre of the trap.

The direction of the kick is given by the polarisation of the light, which is either left or right handed circular giving different interactions with the different m_f levels. The correct polarisations are used so that photons moving towards the centre of the trap will be on resonance with the correct shifted atomic energy level, always driving the atom towards the centre.

Atomic structure necessary for magneto-optical trapping

The lasers needed for the magneto-optical trapping of rubidium 85: (a) & (b) show the absorption (red detuned to the dotted line) and spontaneous emission cycle, (c) & (d) are forbidden transitions, (e) shows that if a the cooling laser excites an atom to the F=3 state, it is allowed to decay to the "dark" lower hyperfine, F=2 state, which would stop the cooling process, if it were not for the repumper laser (f).

As a normal atom has many thousands of times the momentum of a single photon, the cooling of an atom must involve many absorption-spontaneous emission cycles, with the atom losing up to ħk of momenta each cycle . Because of this, if an atom is to be laser cooled, it must possess a specific energy level structure known as a closed optical loop, where following an excitation-spontaneous emission event, the atom is always returned to its original state. ⁸⁵Rubidium, for example, has a closed optical loop between the 5S_1/2 F=3 state and the 5P_3/2 F=4 state. Once in the excited state, the atom is forbidden from decaying to any of the 5P_1/2 states, which would not conserve parity, and is also forbidden from decaying to the 5S_1/2 F=2 state, which would require an angular momentum change of −2, which can not be supplied by a single photon.

Many atoms that do not contain closed optical loops can still be laser cooled, however, by using repump lasers which re-excite the population back into the optical loop after it has decayed to a state outside of the cooling cycle. The magneto-optical trapping of rubidium 85, for example, involves cycling on the closed 5S_1/2 F=3 → 5P_3/2 F=4 transition. On excitation, however, the detuning necessary for cooling gives a small, but non-zero overlap with the 5P_3/2 F=3 state. If an atom is excited to this state, which occurs roughly every thousand cycles, the atom is then free to decay either the F=3, light coupled upper hyperfine state, or the F=2 "dark" lower hyperfine state. If it falls back to the dark state, the atom stops cycling between ground and excited state, and the cooling and trapping of this atom stops. A repump laser, which is resonant with the 5S_1/2 F=2 → 5P_3/2 F=3 transition is used to recycle the population back into the optical loop so that cooling can continue.

Apparatus

Laser

All magneto-optical traps require at least one trapping laser plus any necessary repumper lasers (see above). These lasers need stability, rather than high power, requiring no more than the saturation intensity, but a linewidth much less than the Doppler width, usually several megahertz. Because of their low cost, compact size and ease of use, laser diodes are used for many of the standard MOT species while the linewidth and stability of these lasers is controlled using servo systems, which stabilises the lasers to an atomic frequency reference by using, for example, saturated absorption spectroscopy and the Pound-Drever-Hall technique to generate a locking signal.

Vacuum chamber

The MOT cloud is loaded from a background of thermal vapour. However, the trapping potential in a magneto-optical trap is small in comparison to thermal energies of atoms and most collisions between trapped atoms and the background gas supply enough energy to the trapped atom to kick it out of the trap. If the background pressure is too high, atoms are kicked out of the trap faster than they can be loaded, and the trap does not form. This means that the MOT cloud only forms in a vacuum chamber with a background pressure of less than 10 micropascals (10⁻¹⁰ bar).

The limits to the magneto-optical trap

A MOT cloud in two different density regimes:If the density of the MOT is high enough, the MOT cloud goes from having a Gaussian density distribution (left), to something more exotic (right). In the right hand image, the density is so high that atoms have been blown out of the central trapping region by radiation pressure, to then form a toroidal racetrack mode around it.

The maximum temperature and density of a cloud in a magneto-optical trap is limited by the spontaneously emitted photon in cooling each cycle. While the asymmetry in atom excitation gives cooling and trapping forces, the emission of the spontaneously emitted photon is in a random direction, and therefore contributes to a heating of the atom. Of the two ħk kicks the atom receives in each cooling cycle, the first cools, and the second heats: a simple description of laser cooling which enables us to calculate a point at which these two effects reach equilibrium, and therefore define a lower temperature limit, known as the Doppler cooling limit.

The density is also limited by the spontaneously emitted photon. As the density of the cloud increases, the chance that the spontaneously emitted photon will leave the cloud without interacting with any further atoms becomes non-zero. The absorption, by a neighboring atom, of a spontaneously emitted photon gives a 2ħk momentum kick between the emitting and absorbing atom which can be seen as a repulsive force, similar to coulomb repulsion, which limits the maximum density of the cloud.

Application

As a result of low densities and speeds of atoms achieved by optical cooling, the mean free path in a ball of MOT cooled atoms is very long, and atoms may be treated as ballistic. This is useful for quantum information experiments where it is necessary to have long coherence times ( the time an atom spends in a defined quantum state). Because of the continuous cycle of absorption and spontaneous emission, which causes decoherence, any quantum manipulation experiments must be performed with the MOT beams turned off. In this case, it is common to stop the expansion of the gasses during quantum information experiments by loading the cooled atoms into a dipole trap.

A magneto-optical trap is usually the first step to achieving Bose-Einstein condensation. Atoms are cooled in a MOT down to a few times the recoil limit, and then evaporatively cooled which lowers the temperature and increases the density to the required phase space density.

A MOT of ¹³³Cs was used to make some of the best measurements of CP violation.

References

• The Nobel prize in physics 1997

• Raab E. L. , Prentiss M., Cable A., Chu S., Pritchard D.E. (1987). "Trapping of neutral sodium atoms with radiation pressure". Physical Review Letters 59 (23): 2631–2634. Bibcode 1987PhRvL..59.2631R. doi:10.1103/PhysRevLett.59.2631. PMID 10035608. 

• Metcalf, Harold J. and Straten, Peter van der. (1999). Laser Cooling and Trapping. Springer-Verlag New York, Inc. ISBN 9780387987286. 

• Foot, C.J. (2005). Atomic Physics. Oxford University Press. ISBN 9780198506966. 

• Monroe C, Swann W, Robinson H, Wieman C. (1990-09-24). "Very cold trapped atoms in a vapor cell". Physical Review Letters 65 (13): 1571–1574. Bibcode 1990PhRvL..65.1571M. doi:10.1103/PhysRevLett.65.1571. PMID 10042304. 
• Liwag, John Waruel F. Cooling and trapping of 87Rb atoms in a magneto-optical trap using low-power diode lasers, Thesis 621.39767 L767c (1999)

• K B Davis, M O Mewes, M R Andrews, N J van Druten, D S Durfee, D M Kurn, and W Ketterle (1997-11-27). "Bose-Einstein Condensation in a Gas of Sodium Atoms". Physical Review Letters 75 (22): 3969–3973. Bibcode 1995PhRvL..75.3969D. doi:10.1103/PhysRevLett.75.3969. PMID 10059782.