- Digital cable
In 1989, General Instrument (which was later acquired by Motorola) demonstrated that it was possible to convert an analog cable signal to digital and transmit it in a standard 6-MHz television channel. In the 1990s cable providers began to invest heavily in new digital based distribution systems. Increased competition and programming choices from Direct-broadcast satellite services such as DirecTV, Dish Network, and PrimeStar caused cable providers to seek new ways to provide more programming. Customers were increasingly interested in more channels, pay-per-view programming, digital music services, and high speed internet services. By 2000, most cable providers in the US were offering some form of digital services to their customers.
Digital cable technology has allowed cable providers to compress video channels so that they take up less frequency space and to offer various two-way communication capabilities. This has enabled digital cable providers to offer more channels, video on demand services (without use of a telephone line), telephone services, high speed internet services, and interactive television services. In addition, digital cable technology allows for error correction to ensure the quality of the received signal and uses a secure digital distribution system (i.e. a secure encrypted signal to prevent eavesdropping and theft of service)
Digital cable technology can allow many TV channels to occupy the frequency space that would normally be occupied by a single analog cable TV channel. The number of channels placed on a single analog frequency depends on the compression used. Many cable providers are able to fit about 10 digital SD channels or 2 digital HD channels on a single analog channel frequency. Some providers are able to squeeze more channels onto a single frequency with higher compression, but often this can cause the video quality of the channel to degrade.
The addition of this capability complicates the notion of a "channel" in digital cable (as well as in over-the-air ATSC digital broadcasts). The formal names for the two numbers that now identify a channel are the physical channel and the subchannel.
The physical channel is a number corresponding to a specific 6 MHz frequency range. See: North American cable television frequencies.
The subchannel is a logical channel of data within the physical channel. Technically there can be up to 1024 subchannels in a physical channel, though in practice only a few are used (since the bandwidth must be divided among all the subchannels).
There are two ways providers try to make this easier for consumers. The first, accomplished through PSIP, is where program and channel information is broadcast along with the video, allowing the consumer's decoder (set-top box or display) to automatically identify the many channels and subchannels.
The second (also accomplished through PSIP) is where, in an effort to hide subchannels entirely, many cable companies map virtual channel numbers to underlying physical and sub-channels. For example, a cable company might call channel 5-1 "channel 732" and channel 5-2 "channel 733". This also allows the cable company to change the frequency of a channel without changing what the customer sees as a channel number. In such arrangements, the physical/sub-channel numbers are called the "QAM channel", and the alternative channel designation is called the "mapped channel", "virtual channel", or simply "channel".
In theory, a set-top box can decode the PSIP information from every channel it receives and use that information to build the mapping between QAM channel and virtual channel. However, cable companies do not always reliably transmit PSIP information. Alternatively, CableCards receive the channel mapping and can communicate that to the set-top box.
Digital cable has allowed for out of market television stations to be removed from the basic cable lineup from Channels 2 through 13. They would be moved over to digital cable channels 100 and above for bandwidth preservation. Currently, Comcast Cable outlets in New Jersey and Virginia are adapting this in significantly viewed counties that are bordering nearby television markets.
The standard for signal transmission over digital cable television systems in the United States is now fixed as both 64-QAM and 256-QAM (Quadrature Amplitude Modulation), which is specified in SCTE 07, and is part of the DVB standard (but not ATSC). This method carries 38.47 Mbit/s using 256-QAM on a 6 MHz channel, which can carry nearly two full ATSC 19.39 Mbit/s transport streams. Each 6-MHz channel is typically used to carry 7–12 digital SDTV channels (256-QAM, MPEG2 MP/ML streams of 3–5 Mbit/s). On many boxes with QAM tuners (most notably the DVR boxes), High Definition versions of local channels and some cable channels are available.
Digital Cable allows for the broadcast of EDTV (480p) as well as HDTV (720p, 1080i, and eventually 1080p). By contrast, analog cable transmits programs solely in the 480i format (the lowest television definition in use today).
The ATSC standards include a provision for 16-VSB transmission over cable at 38.4 Mbit/s, but the encoding has not yet gained wide acceptance. Some MATV systems may carry 8-VSB and QAM signals, mostly in apartment buildings and similar facilities that use a combination of terrestrial antennas and cable distribution sources (such as HITS or "Headend in the Sky", a unit of Comcast that delivers digital channels by satellite to small cable systems).
Digital cable channels typically are allocated above 552 MHz, the upper frequency of cable channel 78. (Cable channels above channel 13 are at lower frequencies than UHF broadcast channels with the same number, as seen in North American cable television frequencies.) Between 552 and 750 MHz, there is space for 33 6-MHz channels (231–396 SDTV channels); when going all the way to 864 MHz, there is space for 52 6-MHz channels (364–624 SDTV channels).
In the U.S., digital cable systems with 750 MHz or greater activated channel capacity are required to comply with a set of SCTE and CEA standards, and to provide CableCARDs to customers that request them.
- Digital television
- QAM Tuner
- Cable television in the United States
- Direct-broadcast satellite
- Significantly viewed
- ^ "Decades of proven experience". motorola.com. http://broadband.motorola.com/business/heritage.html. Retrieved 2008-03-05.
- National Cable and Telecommunications Association - Digital Cable
- Digital cable & Digital house
- US CATV Channels and Frequencies table (up to channel 78)
- US CATV Channels and Frequencies table (comprehensive)
Digital television in North America TerrestrialDigital standardsDigital networkssee Template:American broadcast televisionNational deployment CableDigital cable Satellite TV IPTVAT&T U-verse · MSN TVTechnical issues
Wikimedia Foundation. 2010.
Look at other dictionaries:
Digital Cable — TV A service provided by many cable providers, digital cable offers viewers more channels. Contrary to many consumers beliefs, digital cable is not the same as High Definition Television or digital television; rather digital cable simply offers… … Audio and video glossary
Digital Cable Group — Die Digital Cable Group (DCG) ist ein Zusammenschluss von folgenden Schweizer Kabelnetzbetreibern: Besonet AG, Solothurn GGA Maur, Ebmatingen SASAG Kabelkommunikation AG, Schaffhausen Stadtantennen AG, Baar Technische Betriebe Suhr, Suhr WWZ… … Deutsch Wikipedia
iO Digital Cable Service — The logo of iO Digital Cable Contents 1 On Demand services … Wikipedia
IO Digital Cable Service — Interactive Optimum, better known as iO Digital Cable or simply iO, is a digital cable service offered by Cablevision, available in New Jersey, New York, Connecticut, and parts of Pennsylvania. It includes 45 HDTV channels, interactive channels,… … Wikipedia
Virtual Digital Cable — Infobox Company company name = VDC Corporation company company type = Private company slogan = Television Everywhere foundation = 2002 in Highland Park, Illinois, USA location = flagicon|USA Northbrook, Illinois, USA industry = Television,… … Wikipedia
Cable television in the United States — is a common form of television delivery, generally by subscription. Cable television first became available in the United States in 1948, with subscription services in 1949. Data by SNL Kagan shows that as of 2006 about 58.4% of all American… … Wikipedia
Digital television in Canada — (more specifically, digital terrestrial television in Canada or digital over the air television (OTA) in Canada) is transmitted using the ATSC standards developed for and in use in the United States. Because Canada and the U.S. use the same… … Wikipedia
Digital Visual Interface — (DVI) A male DVI D (single link) connector. Type Digital and analog computer video connector Production history … Wikipedia
Cable-ready — is a designation which indicates that a TV set or other television receiving device (such as a VCR or DVR) is capable of receiving cable TV without a set top box. The term originates with analog TV, which uses different frequencies for cable… … Wikipedia
Cable television in the Republic of Ireland — is the most common system for distributing multi channel television in the state. With a 40+ year history and extensive networks of both wired and wireless cable, the Republic of Ireland is amongst the most cabled countries in Europe.HistoryCable … Wikipedia