 Lapse rate

The lapse rate is defined as the rate of decrease with height for an atmospheric variable. The variable involved is temperature unless specified otherwise.^{[1]}^{[2]} The terminology arises from the word lapse in the sense of a decrease or decline; thus, the lapse rate is the rate of decrease with height and not simply the rate of change. While most often applied to Earth's atmosphere the concept can be extended to any gravitationally supported ball of gas.
Contents
Definition
A formal definition from the Glossary of Meteorology^{[3]} is:
 The decrease of an atmospheric variable with height, the variable being temperature unless otherwise specified.
 The term applies ambiguously to the environmental lapse rate and the process lapse rate, and the meaning must often be ascertained from the context.
Mathematical definition
In general, a lapse rate is the negative of the rate of temperature change with altitude change, thus:
where γ is the lapse rate given in units of temperature divided by units of altitude, T = temperature, and z = altitude.
Note: In some cases, Γ or α can be used to represent the adiabatic lapse rate in order to avoid confusion with other terms symbolized by γ, such as the specific heat ratio^{[4]} or the psychrometric constant.^{[5]}Types of lapse rates
There are two types of lapse rate:
 Environmental lapse rate – which refers to the actual change of temperature with altitude for the stationary atmosphere (i.e. the temperature gradient)
 The adiabatic lapse rates – which refer to the change in temperature of a parcel of air as it moves upwards (or downwards) without exchanging heat with its surroundings. The temperature change that occurs within the air parcel reflects the adjusting balance between potential energy and kinetic energy of the molecules of gas that comprise the moving air mass. There are two adiabatic rates:^{[6]}
 Dry adiabatic lapse rate
 Moist (or saturated) adiabatic lapse rate
Environmental lapse rate
The environmental lapse rate (ELR), is the rate of decrease of temperature with altitude in the stationary atmosphere at a given time and location. As an average, the International Civil Aviation Organization (ICAO) defines an international standard atmosphere (ISA) with a temperature lapse rate of 6.49 K(°C)/1,000 m^{[citation needed]} (3.56 °F or 1.98 K(°C)/1,000 Ft) from sea level to 11 km (36,090 ft). From 11 km (36,090 ft or 6.8 mi) up to 20 km (65,620 ft or 12.4 mi), the constant temperature is −56.5 °C (−69.7 °F), which is the lowest assumed temperature in the ISA. The standard atmosphere contains no moisture. Unlike the idealized ISA, the temperature of the actual atmosphere does not always fall at a uniform rate with height. For example, there can be an inversion layer in which the temperature increases with height.
Dry adiabatic lapse rate
The dry adiabatic lapse rate (DALR) is the rate of temperature decrease with height for a parcel of dry or unsaturated air rising under adiabatic conditions. Unsaturated air has less than 100% relative humidity; i.e. its actual temperature is higher than its dew point. The term adiabatic means that no heat transfer occurs into or out of the parcel. Air has low thermal conductivity, and the bodies of air involved are very large, so transfer of heat by conduction is negligibly small.
Under these conditions when the air rises (for instance, by convection) it expands, because the pressure is lower at higher altitudes. As the air parcel expands, it pushes on the air around it, doing work (thermodynamics). Since the parcel does work but gains no heat, it loses internal energy so that its temperature decreases. The rate of temperature decrease is 9.8 °C per 1,000 m (5.38 °F per 1,000 ft) (3.0°C/1,000 ft). The reverse occurs for a sinking parcel of air.^{[7]}
Since for adiabatic process:
 PdV = − VdP / γ
the first law of thermodynamics can be written as
 nc_{v}dT − Vdp / γ = 0
Also since :α = V / n and :γ = c_{p} / c_{v} we can show that:
 c_{p}dT − αdP = 0
where c_{p} is the specific heat at constant pressure and α is the specific volume.
Assuming an atmosphere in hydrostatic equilibrium:^{[8]}
 dP = − ρgdz
where g is the standard gravity and ρ is the density. Combining these two equations to eliminate the pressure, one arrives at the result for the DALR,^{[9]}
 .
Saturated adiabatic lapse rate
When the air is saturated with water vapor (at its dew point), the moist adiabatic lapse rate (MALR) or saturated adiabatic lapse rate (SALR) applies. This lapse rate varies strongly with temperature. A typical value is around 5 °C/km (2.7 °F/1,000 ft) (1.5°C/1,000 ft).
The reason for the difference between the dry and moist adiabatic lapse rate values is that latent heat is released when water condenses, thus decreasing the rate of temperature drop as altitude increases. This heat release process is an important source of energy in the development of thunderstorms. An unsaturated parcel of air of given temperature, altitude and moisture content below that of the corresponding dewpoint cools at the dry adiabatic lapse rate as altitude increases until the dewpoint line for the given moisture content is intersected. As the water vapor then starts condensing the air parcel subsequently cools at the slower moist adiabatic lapse rate if the altitude increases further.
The saturated adiabatic lapse rate is given approximately by this equation from the glossary of the American Meteorology Society:^{[10]}

where: Γ_{w} = Wet adiabatic lapse rate, K/m g = Earth's gravitational acceleration = 9.8076 m/s^{2} H_{v} = Heat of vaporization of water, J/kg r = The ratio of the mass of water vapor to the mass of dry air, kg/kg R = The universal gas constant = 8,314 J kmol^{−1} K^{−1} M = The molecular weight of any specific gas, kg/kmol = 28.964 for dry air and 18.015 for water vapor R / M = The specific gas constant of a gas, denoted as R_{s} R_{sd} = Specific gas constant of dry air = 287 J kg^{−1} K^{−1} R_{sw} = Specific gas constant of water vapor = 462 J kg^{−1} K^{−1} =The dimensionless ratio of the specific gas constant of dry air to the specific gas constant for water vapor = 0.6220 T = Temperature of the saturated air, K c_{pd} = The specific heat of dry air at constant pressure, J kg^{−1} K^{−1}
Significance in meteorology
The varying environmental lapse rates throughout the Earth's atmosphere are of critical importance in meteorology, particularly within the troposphere. They are used to determine if the parcel of rising air will rise high enough for its water to condense to form clouds, and, having formed clouds, whether the air will continue to rise and form bigger shower clouds, and whether these clouds will get even bigger and form cumulonimbus clouds (thunder clouds).
As unsaturated air rises, its temperature drops at the dry adiabatic rate. The dew point also drops (as a result of decreasing air pressure) but much more slowly, typically about −2 °C per 1,000 m. If unsaturated air rises far enough, eventually its temperature will reach its dew point, and condensation will begin to form. This altitude is known as the lifting condensation level (LCL) when mechanical lift is present and the convective condensation level (CCL) absent mechanical lift, in which case, the parcel must be heated from below to its convective temperature. The cloud base will be somewhere within the layer bounded by these parameters.
The difference between the dry adiabatic lapse rate and the rate at which the dew point drops is around 8 °C per 1,000 m. Given a difference in temperature and dew point readings on the ground, one can easily find the LCL by multiplying the difference by 125 m/°C.
If the environmental lapse rate is less than the moist adiabatic lapse rate, the air is absolutely stable — rising air will cool faster than the surrounding air and lose buoyancy. This often happens in the early morning, when the air near the ground has cooled overnight. Cloud formation in stable air is unlikely.
If the environmental lapse rate is between the moist and dry adiabatic lapse rates, the air is conditionally unstable — an unsaturated parcel of air does not have sufficient buoyancy to rise to the LCL or CCL, and it is stable to weak vertical displacements in either direction. If the parcel is saturated it is unstable and will rise to the LCL or CCL, and either be halted due to an inversion layer of convective inhibition, or if lifting continues, deep, moist convection (DMC) may ensue, as a parcel rises to the level of free convection (LFC), after which it enters the free convective layer (FCL) and usually rises to the equilibrium level (EL).
If the environmental lapse rate is larger than the dry adiabatic lapse rate, it has a superadiabatic lapse rate, the air is absolutely unstable — a parcel of air will gain buoyancy as it rises both below and above the lifting condensation level or convective condensation level. This often happens in the afternoon over many land masses. In these conditions, the likelihood of cumulus clouds, showers or even thunderstorms is increased.
Meteorologists use radiosondes to measure the environmental lapse rate and compare it to the predicted adiabatic lapse rate to forecast the likelihood that air will rise. Charts of the environmental lapse rate are known as thermodynamic diagrams, examples of which include SkewT logP diagrams and tephigrams. (See also Thermals).
The difference in moist adiabatic lapse rate and the dry rate is the cause of foehn wind phenomenon (also known as "Chinook winds" in parts of North America).
See also
External links
 definition, equations and tables of lapse rate from the Planetary Data system.
 National Science Digital Library glossary:
 An introduction to lapse rate calculation from first principles from U. Texas
Additional reading
 Beychok, Milton R. (2005). Fundamentals Of Stack Gas Dispersion (4th ed.). authorpublished. ISBN 0964458802. www.airdispersion.com
 R. R. Rogers and M. K. Yau (1989). Short Course in Cloud Physics (3rd ed.). ButterworthHeinemann. ISBN 0750632151.
References
 ^ Mark Zachary Jacobson (2005). Fundamentals of Atmospheric Modeling (2nd ed.). Cambridge University Press. ISBN 052183970X.
 ^ C. Donald Ahrens (2006). Meteorology Today (8th ed.). Brooks/Cole Publishing. ISBN 0495011622.
 ^ Todd S. Glickman (June 2000). Glossary of Meteorology (2nd ed.). American Meteorological Society, Boston. ISBN 1878220349. (Glossary of Meteorolgy)
 ^ Salomons, Erik M. (2001). Computational Atmospheric Acoustics (1st ed.). Kluwer Academic Publishers. ISBN 1402003900.
 ^ Stull, Roland B. (2001). An Introduction to Boundary Layer Meteorology (1st ed.). Kluwer Academic Publishers. ISBN 9027727694.
 ^ Adiabatic Lapse Rate, IUPAC Goldbook
 ^ Danielson, Levin, and Abrams, Meteorology, McGraw Hill, 2003
 ^ Landau and Lifshitz, Fluid Mechanics, Pergamon, 1979
 ^ Kittel and Kroemer, Thermal Physics, Freeman, 1980; chapter 6, problem 11
 ^ Glossary of Meteorology
Meteorological data and variables General Adiabatic processes · Lapse rate · Lightning · Surface solar radiation · Surface weather analysis · Visibility · Vorticity · WindCondensation Convection Temperature Dew point (T_{d}) · Equivalent temperature (T_{e}) · Forest fire weather index · Haines Index · Heat index · Humidex · Humidity · Potential temperature (θ) · Equivalent potential temperature (θ_{e}) · Sea surface temperature (SST) · Wetbulb temperature · Wetbulb potential temperature · Wind chillPressure Categories: Atmospheric thermodynamics
 Climate feedbacks
 Fluid mechanics
Wikimedia Foundation. 2010.
Look at other dictionaries:
lapse rate — lapse′ rate n. mer the rate of decrease of atmospheric temperature with increase of elevation vertically above a given location • Etymology: 1915–20 … From formal English to slang
lapse rate — n. the rate of decrease of an atmospheric variable, usually temperate, with increase of altitude … English World dictionary
lapse rate — Meteorol. the rate of decrease of atmospheric temperature with increase of elevation vertically above a given location. [1915 20] * * * ▪ meteorology rate of change in temperature observed while moving upward through the Earth s atmosphere … Universalium
lapse rate — The rate of decrease of an atmospheric variable with height. However, the term normally refers to the fall of temperature with height. The three types of lapse rates referred to in meteorology are dry adiabatic lapse rate, saturated adiabatic… … Aviation dictionary
lapse rate — noun : the rate of change of any meteorological element with increase of height; specifically : the rate of decrease of temperature with increase of height called also vertical gradient * * * Meteorol. the rate of decrease of atmospheric… … Useful english dictionary
lapse rate — gradientas statusas T sritis Standartizacija ir metrologija apibrėžtis Atmosferos kintamojo dydžio vertės priklausomybė nuo aukščio. atitikmenys: angl. gradient; lapse rate vok. Gradient, m rus. градиент, m pranc. gradient, m … Penkiakalbis aiškinamasis metrologijos terminų žodynas
lapse rate — noun Date: 1918 the adiabatic rate of decrease of atmospheric temperature with increasing altitude … New Collegiate Dictionary
lapse rate — noun The rate of change in atmospheric temperature with increase of height. The variable normally is temperature unless specified otherwise. This is a vertical direction of travel (up or down), and the temperature may rise or fall suddenly … Wiktionary
lapse rate — noun the rate at which air temperature falls with increasing altitude … English new terms dictionary
lapse rate — /ˈlæps reɪt/ (say laps rayt) noun the rate of decrease in an atmospheric variable, usually temperature, occurring with height … Australian English dictionary