- Burglar alarm control panel
A burglar alarm control panel is a wall-mounted unit where the detection devices and wiring of the alarm are ultimately connected and managed. These include devices such as bells,
sirens, door contacts, motion detectors, etc. Typical panels are located in utility closets or access rooms.
The simplest type of burglar alarm control consists of a single
relay. In this type, the sensor circuit (called the "loop" in industrial terminology) holds the relay energized. Since the path for the loop goes through a set of contacts which are normally open (when the relay is restored they are open, when the relay is energized they are closed), when the loop opens, even momentarily, the relay will drop out and stay that way. A second set of contacts on the relay, normally closed (when the relay is restored they are closed, when the relay is energized they are open) is used to operate the annunciator, usually a bell. The system is disarmed by a key-operated shunt which forces the relay to energize, and is armed by closing all traps and then by opening the shunt. While burglar alarm controls are now very elaborate, the single-relay control incorporates all the functionality of any control. These controls and a closely related dual-relay design are still widely used in stand-alone applications, powered by lead-acid batteries.
Modern alarm controls are solid-state devices, and do not use the relays that the older alarm panels used to go into alarm. They make use of relays to modulate the alarm notification device as needed. And they use a relay to seize the telephone line to communicate to the monitoring station. Most switching devices are N.C. (normally closed) circuits, so when the device is not in an alarm condition, the circuit is closed. Most alarm circuits (zones) are also set up to open or close on reading a certain resistance, usually between 1K and 5K
ohms when inactive and double the value when active. This wiring system is called dual loopand allows for both alarm and anti-tamper detections to be incorporated into one circuit (anti-tamper occurs when the resistance level moves outside normal open/close values). This is the standard circuit in most modern systems.
Early (c.a. 1980) solid-state alarm controls used shunt switches or momentary closures on the key circuit to arm or disarm the control. Modern controls can use these arming techniques, but more frequently use a
keypadwhich sends operating information to the control. Thus, there is no point in attacking the keypad, as there is no intelligence in the keypad, it is all located in the control. Also, many controls feature integrated transmitters, using wired telephony or optionally, cellular telephony. These controls also monitor the status of the telephone line, and can be programmed to trip if the telephone line fails (or is cut). The controls which utilize cellular telephony report either periodically or at a pseudo-random interval to the central station, and a failure to report will result in a dispatch.
High-security alarm controls use current and impedance monitoring on the premises, and may report to the central station via dedicated voice-grade or DC (obsolescent) circuit, or by means of multiple-drop AC grade transmitter (multiplex).
* [http://www.wiredburglaralarm.com/What-is-Burglar-Alarm.html What is Burglar Alarm]
* [http://books.google.com/books?id=Zjk3YpdyaxkC&pg=PA42&source=gbs_toc_r&cad=0_0&sig=O2KO5P-hUeu-_M_TfHMxUy-VtNM#PPA54,M1 Security Now - A Guide to Electronic Security By E. Morawski]
Wikimedia Foundation. 2010.
Look at other dictionaries:
Fire alarm control panel — A fire alarm control panel (FACP), also called a fire alarm panel. Technicians usually refer to the FACP as the panel. A fire alarm control panel is the central control device that receives information from input devices (smoke detectors, heat… … Wikipedia
Burglar alarm — Silent alarm redirects here. For the album, see Silent Alarm (album). Burglar (or intrusion), fire and safety alarms are all electronic today. Sensors are connected to a control unit via a low voltage hardwire or narrowband RF signal which is… … Wikipedia
Panic alarm — A panic alarm is an electronic device designed to assist in alerting somebody in emergency situations where a threat to persons or property exists. A panic alarm is frequently but not always controlled by a concealed panic alarm button. These… … Wikipedia
Access control — is the ability to permit or deny the use of a particular resource by a particular entity. Access control mechanisms can be used in managing physical resources (such as a movie theater, to which only ticketholders should be admitted), logical… … Wikipedia
Passive infrared sensor — A Passive InfraRed sensor (PIR sensor) is an electronic device that measures infrared (IR) light radiating from objects in its field of view. PIR sensors are often used in the construction of PIR based motion detectors (see below). Apparent… … Wikipedia
Dual loop — This article refers to the electrical circuit as used in burglar alarms. Several other uses for the term Dual loop may also exist. Dual loop is a method of electrical circuit termination used in electronic security applications, particularly… … Wikipedia
Door — For other uses, see Door (disambiguation). A door is a movable structure used to open and close off an entrance, typically consisting of a panel that swings on hinges or that slides or rotates inside of a space. When open, they admit ventilation… … Wikipedia
Door security — relates to prevention of door related burglaries. Such break ins take place in various forms, and in a number of locations; ranging from front, back and side doors to garage doors. Contents 1 Common residential door types 2 Security weakness of… … Wikipedia
SimplexGrinnell — Infobox Company company name = SimplexGrinnell LP company company type = Subsidiary of Tyco Fire Security foundation = 2001, with roots going back to 1850 s (Grinnell) and 1894 (Simplex) location = Boca Raton, Florida, U.S.A. Corporate Sales… … Wikipedia
Los Angeles Police Department resources — Resources of the Los Angeles Police Department.Police stationsThe Department s deployment of officers has reflected the growth and changes of the City of Los Angeles since the late 1800s. The earliest police station (or division as the early ones … Wikipedia