Copper(II) acetate

Copper(II) acetate
Copper(II) acetate

Small crystals of copper(II) acetate

Copper(II) acetate crystals on copper wire
Identifiers
CAS number 142-71-2 YesY, (anhydrous)
6046-93-1 (monohydrate)
PubChem 8895
ChemSpider 8555 YesY
UNII 39M11XPH03 YesY
Jmol-3D images Image 1
Properties
Molecular formula Cu(CH3COO)2
Molar mass 181.63 g/mol (anhydrous)
199.65 g/mol (monohydrate)
Appearance Dark green crystalline solid
Density 1.88 g/cm3
Melting point

115 °C, 388 K, 239 °F

Boiling point

240 °C, 513 K, 464 °F

Solubility in various solvents 6.8 g/100 mL at 25 °C
approximately 20 g/100 mL hot water
Soluble in alcohol
Slightly soluble in ether and glycerol
Structure
Crystal structure Monoclinic
Hazards
MSDS Baker MSDS
R-phrases 22-36/37/38-50/53
S-phrases 26-60-61
NFPA 704
NFPA 704.svg
0
2
0
Flash point Non-flammable
LD50 710mg/kg oral rat [1]
 YesY (verify) (what is: YesY/N?)
Except where noted otherwise, data are given for materials in their standard state (at 25 °C, 100 kPa)
Infobox references

Copper(II) acetate, also referred to as cupric acetate, is the chemical compound with the formula Cu(OAc)2 where OAc- is acetate (CH3CO2-). The hydrated derivative, which contains one molecule of water for each Cu atom, is available commercially. Anhydrous Cu(OAc)2 is a dark green crystalline solid, whereas Cu(OAc)2(H2O)2 is more bluish-green. Since ancient times, copper acetates of some form have been used as fungicides and green pigments. Today, copper acetates are used as reagents for the synthesis of various inorganic and organic compounds.[2] Copper acetate, like all copper compounds, emits a blue-green glow in a flame.

Contents

Structure

The dinuclear structure of copper(II) acetate dihydrate

Copper acetate monohydrate is described by the formula Cu2(OAc)4(H2O). It adopts the "paddle-wheel" structure seen also for related Rh(II) and Cr(II) tetraacetates.[3][4] One oxygen atom on each acetate is bound to one copper at 1.97 Å (197 pm. Completing the coordination sphere are two water ligands, with Cu-O distances of 2.20 Å (220 pm). The two five-coordinate copper atoms are separated by only 2.65 Å (265 pm), which is close to the Cu--Cu separation in metallic copper.[5] The two copper centers interact resulting in a diminishing of the magnetic moment such that near 90 K, Cu2(OAc)4(H2O)2 is essentially diamagnetic due to cancellation of the two opposing spins. Cu2(OAc)4(H2O)2 was a critical step in the development of modern theories for antiferromagnetic coupling.[6]

Synthesis

Copper(II) acetate synthesized by the method described in the history section leads to impure samples. It is prepared industrially by heating copper(II) hydroxide or copper(II) carbonate with acetic acid.[2]

A second method of copper acetate production is to electrolyze a concentrated aqueous solution of calcium acetate with copper electrodes. As the reaction proceeds the anode oxidizes to produce copper acetate which adheres to the anode's surface and can be removed as crystals. At the cathode calcium ions are reduced to calcium metal and would be deposited, but due to the water content of the solution the calcium is converted to an insoluble calcium hydroxide layer. The drawback with this setup is that the cathode gets coated with insulative calcium hydroxide, which slows the process. To negate this hydroxide buildup mercury is frequently utilized as the cathode; therefore as the process takes place the calcium formed immediately reacts with the mercury to make a calcium-mercury amalgam and the copper acetate formed at the anode is removed periodically. This process generally yields suitably pure copper acetate with slight traces of calcium acetate.

Related compounds

Heating a mixture of anhydrous copper(II) acetate and copper metal affords cuprous acetate: The hydrate form can be dehydrated by heating at 100 °C in a vacuum:[7]

2 Cu + Cu2(OAc)4 → 4 CuOAc

Unlike the copper(II) derivative, copper(I) acetate is colourless and diamagnetic.

Basic copper acetate is prepared by neutralizing an aqueous solution of copper(II) acetate. The basic acetate is poorly soluble. This material is a component of verdigris, the blue-green substance that forms on copper during long exposures to atmosphere.

Uses in chemical synthesis

The uses for copper(II) acetate are more plentiful as a catalyst or oxidizing agent in organic syntheses. For example, Cu2(OAc)4 is used to couple two terminal alkynes to make a 1,3-diyne:[8]

Cu2(OAc)4 + 2 RC≡CH → 2 CuOAc + RC≡C-C≡CR + 2 HOAc

The reaction proceeds via the intermediacy of copper(I) acetylides, which are then oxidized by the copper(II) acetate, releasing the acetylide radical. A related reaction involving copper acetylides is the synthesis of ynamines, terminal alkynes with amine groups using Cu2(OAc)4.[citation needed]

History

Copper(II) acetate was historically prepared in vineyards, since acetic acid is a byproduct of fermentation. Copper sheets were alternately layered with fermented grape skins and dregs left over from wine production and exposed to air. This would leave a blue substance on the outside of the sheet. This was then scraped off and dissolved in water. The resulting solid was used as a pigment, or combined with arsenic trioxide to form copper acetoarsenite, a powerful insecticide and fungicide called Paris Green or Schweinfurt Green.


References

  1. ^ http://www.sargentwelch.com/pdf/msds/Copper_II_Acetate_212.00.pdf
  2. ^ a b H.Wayne Richardson "Copper Compounds" in Ullmann's Encyclopedia of Industrial Chemistry 2005, Wiley-VCH, Weinheim. doi:10.1002/14356007.a07_567
  3. ^ van Niekerk, J. N. Schoening, F. R. L. (1953). "X-Ray Evidence for Metal-to-Metal Bonds in Cupric and Chromous Acetate". Nature 171 (4340): 36–37. doi:10.1038/171036a0. 
  4. ^ Wells, A.F. (1984). Structural Inorganic Chemistry, Oxford: Clarendon Press.
  5. ^ J. Catterick, P. Thornton (1977). "Structures and physical properties of polynuclear carboxylates". Adv. Inorg. Chem. Radiochem. 20: 291–362. http://books.google.com/books?hl=ru&lr=&id=es-Pu2hI5swC&oi=fnd&pg=PA291&dq=related:VV11sw7b1OoJ:scholar.google.com/&ots=o59nIGR4M_&sig=eGl5rS_sRb85QsezUdvD8O3WB8I#v=onepage&q&f=false. 
  6. ^ R. L. Carlin "Magnetochemistry" Springer: Berlin, 1986
  7. ^ S. J. Kirchner, Q. Fernando (1980). "Copper(I) Acetate". Inorg. Synth. 20: 53–55. doi:10.1002/9780470132517.ch16. . see also Parish, E. J.; Kizito, S. A. "Copper(I) Acetate" Encyclopedia of Reagents for Organic Synthesis, 2001 John Wiley & Sons. DOI: 10.1002/047084289X.rc193.
  8. ^ P. Vogel, J. Srogl "Copper(II) Acetate" in "EROS Encyclopedia of Reagents for Organic Synthesis" Copper(II) Acetate, 2005 John Wiley & Sons.

External links


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать реферат

Look at other dictionaries:

  • Copper(II) arsenate — IUPAC name Copper(II) arsenate …   Wikipedia

  • Copper benzoate — Copper benzoate …   Wikipedia

  • Acetate — For other uses, see Acetate (disambiguation). acetate anion …   Wikipedia

  • Copper — For other uses, see Copper (disambiguation) …   Wikipedia

  • Copper(II) carbonate — Other names copper carbonate, cupric carbonate, basic copper carbonate …   Wikipedia

  • Copper aspirinate — Copper aspirinate …   Wikipedia

  • Copper in health — Normal absorption and distribution of copper. Cu = copper, CP = ceruloplasmin, green = ATP7B carrying copper. Copper is an essential trace element that is vital to the health of all living things (humans, plants, animals, and microorganisms). In… …   Wikipedia

  • copper acetate — noun : an acetate of copper: as a. : the normal salt Cu(C2H3O2)2 forming dark green crystals called also cupric acetate b. : any of several basic salts derived from this see verdigris 2 …   Useful english dictionary

  • Rhodium(II) acetate — Rhodium (II) Acetate IUPAC name Rhodium (II) acetate …   Wikipedia

  • Zinc acetate — IUPAC name Zinc acetate …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”