Concrete slab

Concrete slab
Suspended slab under construction, with the formwork still in place.
Suspended slab formwork and rebar in place, ready for concrete pour. On reinforced concrete blockwork supporting walls.

A concrete slab is a common structural element of modern buildings. Horizontal slabs of steel reinforced concrete, typically between 10 and 50 centimeters thick, are most often used to construct floors and ceilings, while thinner slabs are also used for exterior paving.

In many domestic and industrial buildings a thick concrete slab, supported on foundations or directly on the subsoil, is used to construct the ground floor of a building. In high rise buildings and skyscrapers, thinner, pre-cast concrete slabs are slung between the steel frames to form the floors and ceilings on each level.

On the technical drawings, reinforced concrete slabs are often abbreviated to "r.c.slab" or simply "r.c.".

Contents

Thermal performance

There are two main thermal considerations. The first is the question of insulating a floor slab. In older buildings, concrete slabs cast directly on the ground can drain heat from a room. In modern construction, concrete slabs are usually cast above a layer of insulation such as expanded polystyrene, and the slab may contain underfloor heating pipes. However, there are still uses for an uninsulated slab, typically in outbuildings which are not heated or cooled to room temperature. In those cases, casting the slab directly onto a rocky substrate will maintain the slab at or near the temperature of the substrate throughout the year, and can prevent both freezing and overheating.

The second consideration is the high thermal mass, which applies to walls and floors, or wherever the concrete is used within the thermal envelope. It is a disadvantage where the rooms are heated intermittently and require a quick response, as the concrete takes time to warm up, causing a delay in warming the building. But it is an advantage in climates with large daily temperature swings, where the slab acts as a regulator, keeping the building cool by day and warm by night.

Design

For a suspended slab, there are a number of designs to improve the strength-to-weight ratio. In all cases the top surface remains flat, and the underside is modulated:

  • Corrugated, usually where the concrete is poured into a corrugated steel tray. This improves strength and prevents the slab bending under its own weight. The corrugations run across the short dimension, from side to side.
  • A ribbed slab, giving considerable extra strength on one direction.
  • A waffle slab, giving added strength in both directions.

Reinforcement design

  • A one way slab needs moment resisting reinforcement only in its short-direction. Because, the moment along long axes is so small that it can be neglected. When the ratio of the length of long direction to short direction of a slab is greater than 2 it can be considered as a one way slab.
  • A two way slab needs moment resisting reinforcement in both directions. If the ratio of the lengths of long and short side is less than one then moment in both direction should be considered in design.

Construction

A concrete slab may be prefabricated or in situ. Prefabricated concrete slabs are built in a factory and transported to the site, ready to be lowered into place between steel or concrete beams. They may be pre-stressed (in the factory), post-stressed (on site), or unstressed. It is vital that the supporting structure is built to the correct dimensions, or the slabs may not fit.

In situ concrete slabs are built on the building site using formwork - a type of boxing into which the wet concrete is poured. If the slab is to be reinforced, the rebars are positioned within the formwork before the concrete is poured in. Plastic tipped metal, or plastic bar chairs are used to hold the rebar away from the bottom and sides of the form-work, so that when the concrete sets it completely envelops the reinforcement. For a ground slab, the form-work may consist only of sidewalls pushed into the ground. For a suspended slab, the form-work is shaped like a tray, often supported by a temporary scaffold until the concrete sets.

The formwork is commonly built from wooden planks and boards, plastic, or steel. On commercial building sites today, plastic and steel are more common as they save labour. On low-budget sites, for instance when laying a concrete garden path, wooden planks are very common. After the concrete has set the wood may be removed, or left there permanently.

In some cases formwork is not necessary - for instance, a ground slab surrounded by brick or block foundation walls, where the walls act as the sides of the tray and hardcore acts as the base.

See also

External links


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать реферат

Look at other dictionaries:

  • concrete slab — /kɒnkrit ˈslæb/ (say konkreet slab) noun a large single piece of concrete which forms the base of a building …  

  • Concrete cancer — is a colloquial name for the deterioration of concrete caused by the presence of contaminants or the action of weather combined with atmospheric properties. While often used in the context of the rusting of concrete reinforcement bar (rebar), the …   Wikipedia

  • Concrete leveling — is a procedure that attempts to correct an uneven concrete surface by altering the foundation that the surface sits upon. It is a cheaper alternative to having replacement concrete poured, and commonly performed at small businesses and private… …   Wikipedia

  • Concrete degradation — may have various causes. Concrete can be damaged by fire, aggregate expansion, sea water effects, bacterial corrosion, calcium leaching, physical damage and chemical damage (from carbonation, chlorides, sulfates and distilled water). This process …   Wikipedia

  • slab — [slæb] n 1.) a thick flat piece of a hard material such as stone ▪ a concrete slab ▪ paving slabs slab of ▪ They used a slab of concrete as a lid. 2.) slab of cake/chocolate/meat etc a large flat piece of cake etc 3.) …   Dictionary of contemporary English

  • Slab — can refer to:Physical objects and substances* A broad flat square or rectangular piece of wood, stone or other solid material used to construct buildings, pavements, patios, paths, etc: see Paver (flooring) and flagstone. * An outside piece cut… …   Wikipedia

  • CONCRETE —    Concrete is a compound made from sand, gravel, and cement, while cement is a mixture of minerals that become hard when water is added, binding the sand and gravel into a solid mass. Although concrete is traditionally considered an Ancient… …   Historical Dictionary of Architecture

  • Concrete moisture meters — Moisture meters have been used for decades to measure different types of moisture content in different materials and substances. Concrete meters have evolved from the successful wood moisture meter as flooring contractors tried to use their wood… …   Wikipedia

  • Concrete moisture meter — A concrete moisture meter is a type of moisture meter used by installers of flooring to measure the moisture levels of concrete. These meters have been used for decades to measure the moisture content in different materials and substances.… …   Wikipedia

  • Concrete — This article is about the construction material. For other uses, see Concrete (disambiguation). Outer view of the Roman Pantheon, still the largest unreinforced solid concrete dome.[1] …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”