Air-free technique

Air-free technique

Air-free techniques refer to a range of manipulations in the chemistry laboratory for the handling of compounds that are air-sensitive. These techniques prevent the compounds from reacting with components of air, usually water and oxygen; less commonly carbon dioxide and nitrogen. A common theme among these techniques is the use of a high vacuum to remove air, and the use of an inert gas: preferably argon, but often nitrogen.

The two most common types of air-free technique involve the use of a glovebox and a Schlenk line. In both methods, glassware (often Schlenk tubes) are pre-dried in ovens prior to use. They may be flame-dried to remove adsorbed water. Prior to coming into an inert atmosphere, vessels are further dried by "purge-and-refill" — the vessel is subjected to a vacuum to remove gases and water, and then refilled with inert gas. This cycle is usually repeated three times or the vacuum is applied for an extend period of time. One of the differences between the use of a glovebox and a Schlenk line is where the "purge-and-refill" cycle is applied. When using a glovebox the "purge-and-refill" is applied to an airlock attached to the glovebox, commonly called the "port" or "ante-chamber". In contrast when using a Schlenk line the "purge-and-refill" is applied directly to the reaction vessel through a hose or ground glass joint that is connected to the manifold. [Duward F. Shriver and M. A. Drezdzon "The Manipulation of Air-Sensitive Compounds" 1986, J. Wiley and Sons: New York. ISBN 0-471-86773-X.]

Glovebox

The most straightforward type of air-free technique is the use of a glovebox. A glove bag uses the same idea, but is usually a poorer substitute because it is more difficult to purge, and less well sealed. Inventive ways of accessing items beyond the reach of the gloves exist, such as the use of tongs and strings. The main drawbacks to using a glovebox are the cost of the glovebox itself, and limited dexterity wearing the gloves.

In the glovebox, conventional laboratory equipment can often be set up and manipulated, despite the need to handle the apparatus with the gloves. By providing a sealed but recirculating atmosphere of the inert gas, the glove box necessitates few other precautions. Cross contamination of samples due to poor technique is also problematic, especially where a glovebox is shared between workers using differing reagents; volatile ones in particular.

Two styles have evolved in the use of gloveboxes for synthetic chemistry. In a more conservative mode, they are used solely to store, weigh, and transfer air-sensitive reagents. Reactions are thereafter carried out using Schlenk techniques. The gloveboxes are thus only used for the most air-sensitive stages in an experiment. In their more liberal use, gloveboxes are used for the entire synthetic operations including reactions in solvents, work-up, and preparation of samples for spectroscopy.

Not all reagents and solvents are acceptable for use in the glovebox, although again, different laboratories adopt different cultures. The "box atmosphere" is usually continuously deoxygenated over a copper catalyst. Certain volatile chemicals such as halogenated compounds and especially strongly coordinating species such as phosphines and thiols can be problematic because they irreversibly poison the copper catalyst. Because of this problem, many experimentalists choose to handle such compounds using Schlenk techniques. In the more liberal use of gloveboxes, it is accepted that the copper catalyst will require more frequent replacement but this cost is considered to be an acceptable trade-off for the efficiency of conducting an entire synthesis within a protected environment

chlenk-line

The other main technique for the preparation and handing of air-sensitive compounds are associated with the use of a Schlenk line. The main techniques include:
* counterflow additions, where air-stable reagents are added to the reaction vessel against a flow of inert gas.
* the use of syringes and rubber septa to transfer liquids and solutions
* "cannula transfer", where liquids or solutions of air-sensitive reagents are transferred between different vessels stoppered with septa using

Glassware are usually connected via tightly-fitting and greased ground glass joints. Round bends of glass tubing with ground glass joints may be used to adjust the orientation of various vessels.

Filtration under inert conditions poses a special challenge that is usually tackled with specialized glassware. A Schlenk filter consists of sintered glass funnel fitted with joints and stopcocks. By fitting the pre-dried funnel and receiving flask to the reaction flask against a flow of nitrogen, carefully inverting the set-up, and turning on the vacuum appropriately, the filtration may be accomplished with minimal exposure to air.

Other air-free methods

* air-free distillation - e.g. see reflux still, Perkin triangle
* air-free filtration - e.g. see filter stick (see gallery below), swivel frit
* air-free sublimation - see gallery below for a drawing scheme for an example
* air-free solid addition - e.g. see solid addition tube, swivel frit
* air-free liquid addition - e.g. see cannulation, syringing, dropping funnel, vacuum transfer
* air-free NMR tube preparation

Associated preparations

Commercially available purified inert gas (argon or nitrogen) is adequate for most purposes. However, for certain applications, it is necessary to further remove water and oxygen. This additional purification can be accomplished by piping the inert gas line through a heated column of copper catalyst, which converts the oxygen to copper oxide. Water is removed by piping the gas through a column of desiccant such as phosphorus pentoxide or molecular sieves.

Air- and water-free solvents are also necessary. If high-purity solvents are available in nitrogen-purged Winchesters, they can be brought directly into the glovebox. For use with Schlenk technique, they can be quickly poured into Schlenk flasks charged with molecular sieves, and degassed. More typically, solvent is dispensed directly from a still or solvent purification column.

Degassing

Two procedures for degassing are common. The first is known as "freeze-pump-thaw" — the solvent is frozen under liquid nitrogen, and a vacuum is applied. Thereafter, the stopcock is closed and the solvent is thawed in warm water, allowing trapped bubbles of gas escape. [cite web | title = Freeze-Pump-Thaw Degassing of Liquids | author = Mark Lonergan | publisher = University of Oregon | url = http://www.uoregon.edu/~lnrgn/Assets/FPT.pdf]

The second procedure is to simply subject the solvent to a vacuum. Stirring or mechanical agitation using a ultrasonicator is useful. Dissolved gases evolve first; once the solvent starts to evaporate, noted by condensation outside the flask walls, the flask is refilled with inert gas. Both procedures are repeated three times.

Drying

Solvent are traditionally purified by distillation over an appropriate desiccant under an inert atmosphere. The main problem with the use of sodium as a desiccant (below its melting point) is associated with the slow rate of reaction between a solid and a solution. When however, the desiccant is soluble, the speed of drying is much higher. Benzophenone is often used to generate such a soluble drying agent. An advantage to this application is the intense blue color of the ketyl radical anion. Thus, sodium/benzophenone can be used as an indicator of air-free and moisture-free conditions in the purification of solvents by distillation. [cite web | author = Nathan L. Bauld | publisher = University of Texas | year = 2001 | title = Unit 6: Anion Radicals | url = http://research.cm.utexas.edu/nbauld/unit6_anrad.htm] [cite book | author = W. L. F. Armarego and C. Chai | title = Purification of laboratory chemicals | year = 2003 | publisher = Butterworth-Heinemann | city = Oxford | isbn = 0750675713]

However, distillation stills are fire hazards and are increasingly being replaced by alternative solvent-drying systems. Particularly popular is the filtration of deoxygenated solvents through columns filled with activated alumina. [cite journal | author = Pangborn, A. B.; Giardello, M. A.; Grubbs, R. H.; Rosen, R. K. and Timmers, F. J. | title = Safe and Convenient Procedure for Solvent Purification | journal = Organometallics | year = 1996 | volume = 15 | issue = 5 | pages = 1518–20 | doi = 10.1021/om9503712]

Drying of solids can be brought about by storing the solid over a drying agent such as chem|P|2|O|5 or silica, storing in a drying oven/vacuum-drying oven, heating under a high vacuum or in a drying pistol, or to remove trace amounts of water, simply storing the solid in a glove box that has a dry atmosphere.

Alternatives

Both these techniques require rather expensive equipment. Where air-free requirements are not as stringent, other techniques exist. For example, for preparing Grignard reagents which hydrolyze on exposure to water, it is usually sufficient to connect a guard tube filled with calcium chloride to the reflux condenser to prevent moisture contamination.

"In situ" desiccants such as molecular sieves, or the removal of water by azeotropic distillation can also be used.

References

ee also

*Sparging (chemistry)
*Degasification

External links

*
*
*
*

Gallery


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать реферат

Look at other dictionaries:

  • Air guitar — Playing air guitar is a form of dance and movement in which the performer pretends to play rock or heavy metal style electric guitar solos. Playing an air guitar usually consists of exaggerated strumming and picking motions and is often coupled… …   Wikipedia

  • Air pollution — from World War II production Smog over …   Wikipedia

  • Free-diving — Free diver with monofin, ascending. Freediving is any of various aquatic activities that share the practice of breath hold underwater diving. Examples include breathhold spear fishing, freedive photography, apnea competitions and, to a degree,… …   Wikipedia

  • Free-fight — Combat libre La victoire en combat libre est souvent lié à un knockout ou à une soumission (technique d abandon). Le combat libre est un sport de combat complet associant pugilat et lutte au corps à corps, dans lequel les deux combattants peuvent …   Wikipédia en Français

  • Free Fight — Combat libre La victoire en combat libre est souvent lié à un knockout ou à une soumission (technique d abandon). Le combat libre est un sport de combat complet associant pugilat et lutte au corps à corps, dans lequel les deux combattants peuvent …   Wikipédia en Français

  • Free fight — Combat libre La victoire en combat libre est souvent lié à un knockout ou à une soumission (technique d abandon). Le combat libre est un sport de combat complet associant pugilat et lutte au corps à corps, dans lequel les deux combattants peuvent …   Wikipédia en Français

  • Technique d'interrogatoire renforcée — Arrivée de nouveaux détenus au Camp X Ray du centre de détention de Guantánamo où des techniques d interrogatoire renforcées ont été utilisées Technique d’interrogatoire renforcée (enhanced interrogation technique) est un euphémisme utilisée par… …   Wikipédia en Français

  • Technique de projection cinématographique — Projection cinématographique Cinéma …   Wikipédia en Français

  • Air well (condenser) — High mass air well of Belgian engineer Achile Knapen in Trans en Provence …   Wikipedia

  • Air de cour — The Air de cour was a popular type of secular vocal music in France in the very late Renaissance and early Baroque period, from about 1570 until around 1650. From approximately 1610 to 1635, during the reign of Louis XIII, this was the… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”