Clam digging

"Clam digger" redirects here. For the trouser style, see Three quarter pants.

Clam digging in Haneda, 1937

Clam digging is a common means of harvesting clams from below the surface of the tidal mud flats where they live. It is done both recreationally (for enjoyment or as a source of food) and commercially (as a source of income). Commercial digging is colloquially referred to as clamming, and is done by a clammer.

Amateur clam digging is often done using a straight long-handled spading fork or a spading shovel.

Commercial clamming for the larger surf and quahog clams (soup clams) is primarily done offshore, via mechanical dredging. To harvest cultivated clam beds, aquaculturalists often use a much smaller version (hand pulled) of the offshore dredge. Another form of commercial clamming is done from a flat decked boat using a clamrake with a telescopic handle. The head of these rakes have long tines attached to a "basket-like" cage in which the clams are collected.

Clam digging in Long Island, 1957

In the Minas Basin area of Nova Scotia digging for soft-shelled clams is usually done with a clam hack, a spading fork with its short handle bent perpendicularly away from the fork's head. A digger typically uses the hack by grasping the spine of the prongs in one hand and the handle of the fork in the other to push the hack down into the mud, clay, or sand and then pull it up and towards him/herself. This digging action opens up the soil to expose the clams. Those clams legally long enough (44 mm/1.7 in in Nova Scotia) are then taken by hand and put into a peck-size (9 litre) bucket used for measuring the volume of clams collected.

Clam digging on the New England coast is done using a "clam hoe" (a pitchfork with the handle cut off about 18 in/460 mm from the tines then bent about 70 degrees) and a "roller" (a half bushel basket built using wood lathes or wire mesh) and hip waders (boot that extend up to the top of the legs).

Another popular method for bay clamming is the use of specialized tongs from a boat. Operators use the long tongs to probe the sand for clams. Clam tongs appear very much like two clamrakes with teeth hinged like scissors.