Locking hubs

Locking hubs, also known as free wheeling hubs are an accessory fitted to many four-wheel drive vehicles, allowing the front wheels to be manually disconnected from the front half shafts.

Since many older four wheel drive vehicles do not have a centre differential or equivalent (eg. a viscous coupling), they should only be used in four wheel drive mode when traction is limited, otherwise transmission wind-up can occur. Because of this, many of these vehicles will spend most of their time in two wheel drive, and locking hubs allow elements of the drivetrain that are not needed in two wheel drive to be disconnected. With the hubs disengaged and the transmission in 2WD, the whole front axle and differential are inactive.

Without locking hubs, the front wheels would turn the front half shafts, which would turn the front differential and driveshaft. Locking hubs, when switched appropriately, will allow the front wheels to turn independently of the drivetrain.

Suggested benefits of locking hubs include better fuel efficiency, quieter operation, less vibration, and lower wear. Exactly how great these benefits are is open to debate, with many feeling that they are outweighed by the disadvantages below.

In older vehicles, manual locking hubs are used to disengage the front wheels. This requires getting off the vehicle to engage or disengage the front wheels. If road conditions are irregular, these vehicles can be used in 2WD mode with the locks engaged (by disengaging 4WD with the internal lever or switch) and 4WD needs only to be engaged when road conditions require it.

In more modern 4WD vehicles automatic locking hubs are often used, which as the name implies engage automatically when 4WD is activated from the inside of the vehicle. The main advantage is that the driver does not need to leave the vehicle to activate 4WD or drive the vehicle in 2WD with the front axle engaged. The disadvantage with this system is that most designs require the vehicle to move some distance (usually a whole wheel turn, normally in a specific direction) in order for the hubs to engage or disengage (in many cases 4WD can be engaged with the vehicle in movement). This might not be possible if the vehicle gets completely stuck before engaging 4WD, so automatic hubs require more caution on the drivers part.

4WD vehicles that do not have locking hubs have either permanent 4WD or partial time 4WD with a permanently connected front axle (in the case of a vehicle with permanent rear traction), which is active but not under load when in 2WD mode.

Disadvantages of locking hubs include the fact that it is necessary to leave the vehicle to engage them in the manual case, and the need to plan ahead and engage 4WD before getting stuck in the case of automatic hubs. Also, in some axle designs (such as those used on older Land Rovers), the top swivel bearing can become starved of lubrication, which is normally supplied by oil which is thrown up by the axle, unless the hubs are locked every few hundred miles. Since locking hubs generally do not require a key to operate, they can be maliciously locked or unlocked by persons other than the vehicle owner.

ee also

* Freewheel