Base station

Base station

The term base station can be used in the context of land surveying, wireless computer networking, and wireless communications.

Land surveying

In the context of external land surveying, a base station is a GPS receiver at an accurately-known fixed location which is used to derive correction information for nearby portable GPS receivers. This correction data allows propagation and other effects to be corrected out of the position data obtained by the mobile stations, which gives greatly increased location precision and accuracy over the results obtained by uncorrected GPS receivers.

Computer networking

In the area of wireless computer networking, a base station is a radio receiver/transmitter that serves as the hub of the local wireless network, and may also be the gateway between a wired network and the wireless network. It typically consists of a low-power transmitter and wireless router.

ee also

* Access point base station
* IEEE 802.11
* Signal strength

Wireless communications

In radio communications, a base station is a wireless communications station installed at a fixed location and used to communicate as part of either:
* a push-to-talk two-way radio system, or;
* a wireless telephone system such as cellular CDMA or GSM.


=Base station

Two-way radio

Professional

In professional two-way radio systems, a base station is used to maintain contact with a dispatch fleet of hand-held or mobile radios, and/or to activate one-way paging receivers. The base station is one end of a communications link. The other end is a movable vehicle-mounted radio or walkie-talkie. ["Evaluating Regional Alternatives: Systems Design Considerations," "Planning Emergency Medical Communications: Volume 2, Local/Regional Level Planning Guide", (Washington, D.C.: National Highway Traffic Safety Administration, US Department of Transportation, 1995) pp. 39-43.] Examples of base station uses in two-way radio include the dispatch of tow trucks and taxicabs.

. Each taxi dispatcher could communicate with taxis in either Boston or Providence by selecting the respective base station on his or her console. [Base stations in land mobile systems are often located at remote sites such as hilltops or water towers. Some are controlled from two or more locations. For example, a base station used to communicate with taxis may be connected to remote control consoles at both a taxi company office and an answering service for after-hours calls. The taxi company and answering service may be miles apart. Single channel base stations reduce confusion by eliminating the possibility that the wrong channel may be selected.]

In dispatching centers it is common for eight or more radio base stations to be connected to a single dispatching console. Dispatching personnel can tell which channel a message is being received on by a combination of local protocol, unit identifiers, volume settings, and busy indicator lights. A typical console has two speakers identified as "select" and "unselect". Audio from a primary selected channel is routed to the select speaker and to a headset. Each channel has a busy light which flashes when someone talks on the associated channel. [To read more about multi-channel consoles, look at the service manual for a relatively simple console: "8-Channel Remote Console, 120, 220, 240 V AC or 12 V DC T16167 AM or BM", 68-81021E80, (Schaumburg, Illinois: Motorola, Inc. 1980.) This is a relatively simple analog console compared to large, enterprise-level Centracom-series units.]

Base stations can be local controlled or remote controlled. Local controlled base stations are operated by front panel controls on the base station cabinet. Remote control base stations can be operated over tone- or DC-remote circuits. The dispatch point console and remote base station are connected by leased private line telephone circuits, (sometimes called "RTO circuit"s), a DS-1, or radio links. [The term "RTO circuit" is legacy jargon and comes from Bell System billing terminology. RTO circuits refer to analog radio remote control and radio broadcast leased telephone circuits.] The consoles multiplex transmit commands onto remote control circuits. Some system configurations require duplex, or four wire, audio paths from the base station to the console. Others require only a two-wire or half duplex link. [For a brief discussion of remote controlled base stations, see: "Evaluating Regional Alternatives: Systems Design Considerations," "Planning Emergency Medical Communications: Volume 2, Local/Regional Level Planning Guide", (Washington, D.C.: National Highway Traffic Safety Administration, US Department of Transportation, 1995) pp. 39-41. Tone remote controls are described in this section.]

Interference could be defined as receiving any signal other than from a radio in your own system. To avoid interference from users on the same channel, or interference from nearby strong signals on another channel, professional base stations use a combination of: [Block diagram is from: "Figure 8: Bandpass Cavity/Isolator Location," "Planning Emergency Medical Communications: Volume 2, Local/Regional Level Planning Guide", (Washington, D.C.: National Highway Traffic Safety Administration, US Department of Transportation, 1995) pp. 57.] [Bulleted items condensed from, "EMS Communications," "System Coordination," and "Site Engineering," in "Planning Emergency Medical Communications: Volume 2, Local/Regional Level Planning Guide", (Washington, D.C.: National Highway Traffic Safety Administration, US Department of Transportation, 1995) pp. 10-19, 55-58.]
* minimum receiver specifications and filtering. [For an example of receiver specifications, see, "Table 9-3," "800 MHz Trunked Radio Request for Proposals: Public Safety Projects Office," (Oklahoma City, Oklahoma: Oklahoma City Municipal Facilities Authority, 2000, pp. 181. ] [A list of types of filtering used to prevent interference between equipment at the same site is included in "6.2.4 Electromagnetic Compatibility Studies," "800 MHz Trunked Radio Request for Proposals: Public Safety Projects Office," (Oklahoma City, Oklahoma: Oklahoma City Municipal Facilities Authority, 2000, pp. 119. ] [More detail of interference reduction equipment is provided in, "9.1.2 Base Station/Mobile Relay, 800 MHz," "800 MHz Trunked Radio Request for Proposals: Public Safety Projects Office," (Oklahoma City, Oklahoma: Oklahoma City Municipal Facilities Authority, 2000, pp. 165-168.]
* analysis of other frequencies in use nearby.
* in the US, coordination of shared frequencies by coordinating agencies. [For example, US federal government systems are coordinated and licensed by the National Telecommunications and Information Administration. Business/Industrial Pool licences are coordinated by the Personal Communications Industry Association (PCIA) and licensed by the Federal Communicastions Commission.]
* locating equipment so that terrain blocks interfering signals.
* use of directional antennas to reduce unwanted signals.

Base stations are sometimes called "control" or "fixed" stations in US Federal Communications Commission licensing. These terms are defined in regulations inside Part 90 of the commissions regulations. In US licensing jargon, types of base stations include:
* A fixed station is a base station used in a system intended only to communicate with other base stations. A "fixed" station can also be radio link used to operate a distant base station by remote control. (No mobile or hand-held radios are involved in the system.)
* A control station is a base station used in a system with a repeater where the base station is used to communicate through the repeater.
* A temporary base is a base station used in one location for less than a year.
* A repeater is a type of base station that extends the range of hand-held and mobile radios.

Amateur and hobby

In Amateur radio, a base station also communicates with mobile rigs but for hobby or family communications. Amateur systems sometimes serve as dispatch radio systems during disasters, search and rescue mobilizations, or other emergencies.

An Australian UHF CB base station is another example of part of a system used for hobby or family communications.

Wireless telephone

Wireless telephone differ from two-way radios in that:
* wireless telephones are circuit switched: the communications paths are set up by dialing at the start of a call and the path remains in place until one of the callers hangs up.
* wireless telephones communicate with other telephones usually over the public switched telephone network.

A wireless telephone base station communicates with a mobile or hand-held phone. For example, in a wireless telephone system, the signals from one or more mobile telephones in an area are received at a nearby base station, which then connects the call to the land-line network. Other equipment is involved depending on the system architecture. Mobile telephone provider networks, such as European GSM networks, may involve carrier, microwave radio, and switching facilities to connect the call. In the case of a portable phone such as a US cordless phone, the connection is directly connected to a wired land line.

Emissions issues

While low levels of radio-frequency power are usually considered to have negligible effects on health, national and local regulations restrict the design of base stations to limit exposure to electromagnetic fields. Technical measures to limit exposure include restricting the radio frequency power emitted by the station, elevating the antenna above ground level, changes to the antenna pattern, and barriers to foot or road traffic. For typical base stations, significant electromagnetic energy is only emitted at the antenna, not along the length of the antenna tower.

Because mobile phones and their base stations are two-way radios, they produce radio-frequency (RF) radiation (that's how they communicate), and they expose people near them to RF radiation giving concerns about mobile phone radiation and health. Hand-held mobile telephones are relatively low power so the RF radiation exposures from them are generally low.

The consensus of the scientific community is that the power from these mobile phone base station antennas is too low to produce health hazards as long as people are kept away from direct access to the antennas. However, current international exposure guidelines (INCIRP) are based largely on the "thermal" effects of base station emissions. Some scientists have questioned whether there are "non thermal" effects from being exposed to low level RF such as are transmitted from mobile phone base stations. Such 'non-thermal' effects include how the actual frequencies interfere with the human brain and all other cells in the human body.

ee also

* Base Transceiver Station
* Base Station Controller
* Mobile Switching Center
* Macrocell
* Microcell
* Picocell
* Femtocell
* Access point base station
* Cell site
* Cellular repeater
* Mobile phone
* Mobile phone radiation and health
* Portable phone
* Signal strength
* Audio level compression

Notes

External links

* [http://www.osha.gov/SLTC/radiofrequencyradiation/ Occupational Safety and Health Admin. Non-Ionizing Radiation Exposure Guidelines.]
* [http://www.emssixus.com/icnirp.php ICNIRP Compliance explained]


Wikimedia Foundation. 2010.

Игры ⚽ Поможем написать курсовую

Look at other dictionaries:

  • base station — bazinė stotis statusas T sritis automatika atitikmenys: angl. base station vok. Hauptstation, f rus. базовая станция, f pranc. station de base, f …   Automatikos terminų žodynas

  • base station — a unit functioning as a transmitter and receiver of broadcasting or other signals, as in connection with a CB radio or mobile phone. * * * base station noun (telecommunications) A radio and mobile phone service provider, relaying calls between… …   Useful english dictionary

  • base station — bazinė radijo ryšio stotis statusas Aprobuotas sritis elektroniniai ryšiai apibrėžtis Sausumos radijo ryšio stotis, tam tikroje teritorijoje užtikrinanti ryšį su ten esančiomis sausumos judriosiomis radijo ryšio stotimis. trumpoji forma bãzinė… …   Lithuanian dictionary (lietuvių žodynas)

  • base station — base′ sta tion n. tgp rtv a unit functioning as a transmitter and receiver of broadcasting or other signals, as for a CB radio or mobile phone …   From formal English to slang

  • Base station subsystem — The Base Station Subsystem (BSS) is the section of a traditional cellular telephone network which is responsible for handling traffic and signaling between a mobile phone and the network switching subsystem. The BSS carries out transcoding of… …   Wikipedia

  • Base Station Controller — Der Base Station Controller (BSC), englisch für Basisstations Steuereinrichtung, ist ein Netzelement des digitalen GSM Mobilfunknetzes. Inhaltsverzeichnis 1 Allgemeines 2 Aufgaben des Base Station Controller 3 Schnittstellen …   Deutsch Wikipedia

  • Base Station Subsystem — La BSS au sein d un réseau GSM (schéma simplifié). Le sous système des stations de Base (Base Station Subsystem) est la partie radio du réseau de téléphonie mobile GSM, chargée de la connexion entre la Station Mobile (MS) et la partie commutation …   Wikipédia en Français

  • Base Station Subsystem — Das Base Station Subsystem (BSS) (deutsch: Basisstationsteilsystem) bezeichnet den funkbezogenen Teil eines GSM Mobilfunknetzes. Aufbau Das BSS besteht aus einer oder mehreren BTS (Base Transceiver Station), mindestens einem BSC (Base Station… …   Deutsch Wikipedia

  • Base Station Controller — Pour les articles homonymes, voir BSC. BSC, ou Base Station Controller (en français, Contrôleur de Station de base) est l un des éléments du réseau GSM. Son rôle est de commander un certain nombre de BTS (jusqu à plusieurs centaines). À leur tour …   Wikipédia en Français

  • base station area — bazinės stoties zona statusas T sritis automatika atitikmenys: angl. base station area vok. Hauptstationszone, f; Letstationszone, f rus. зона базовой станции, f pranc. zone de la station de base, f …   Automatikos terminų žodynas

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”