Diffuser (thermodynamics)

Diffuser (thermodynamics)

A diffuser is the mechanical device that is designed to control the characteristics of a fluid at the entrance to a thermodynamic open system. Diffusers are used to slow the fluid's velocity and to enhance its mixing into the surrounding fluid. In contrast, a nozzle is often intended to increase the discharge velocity and to direct the flow in one particular direction.

Frictional effects may sometimes be important, but usually they are neglected. However, the external work transfer is always assumed to be zero. It is also assumed that changes in thermal energy are significantly greater than changes in potential energy and therefore the latter can usually be neglected for the purpose of analysis.

HVAC

A round diffuser in an HVAC system

Diffusers are very common in heating, ventilating, and air-conditioning systems.[1] Diffusers are used on both all-air and air-water HVAC systems, as part of room air distribution subsystems, and serve several purposes:

  • To deliver both conditioning and ventilating air
  • Evenly distribute the flow of air, in the desired directions
  • To enhance mixing of room air into the primary air being discharged
  • Often to cause the air jet(s) to attach to a ceiling or other surface, taking advantage of the Coandă effect
  • To create low-velocity air movement in the occupied portion of room
  • Accomplish the above while producing the minimum amount of noise

When possible, dampers, extractors, and other flow control devices should not be placed near diffusers' inlets (necks), either not being used at all or being placed far upstream. They have been shown to dramatically increase noise production. For as-cataloged diffuser performance, a straight section of duct needs serve a diffuser. An elbow, or kinked flex duct, just before a diffuser often leads to poor air distribution and increased noise.

Diffusers may be round, rectangular, textile or linear slot diffusers (LSDs), for example. This last type takes the form of one or several long, narrow slots (hence the name), often semi-concealed in a fixed or suspended ceiling.

Occasionally, diffusers are used in reverse fashion, as air inlets or 'returns'. This is especially true for LSDs and 'perf' diffusers. But more commonly, grilles are used as return or exhaust air inlets.

See also

References

  1. ^ Designer's Guide to Ceiling-Based Air Diffusion, ASHRAE, Inc., Atlanta, GA, USA, 2002

Wikimedia Foundation. 2010.

Игры ⚽ Нужен реферат?

Look at other dictionaries:

  • Diffuser — can refer to any device that diffuses in some manner such as: In aerodynamics Diffuser (automotive), a shaped section of a car s underbody which improves the car s aerodynamic properties divergent part of the flute[clarification needed] divergent …   Wikipedia

  • Centrifugal compressor — Centrifugal compressors, sometimes termed radial compressors, are a sub class of dynamic axisymmetric work absorbing turbomachinery.[1] Centrifugal impeller with a highly polished surface likely to improve performance …   Wikipedia

  • oxidation–reduction reaction — ▪ chemical reaction Introduction also called  redox reaction        any chemical reaction in which the oxidation number of a participating chemical species changes. The term covers a large and diverse body of processes. Many oxidation– reduction… …   Universalium

  • Jet engine — For a general overview of aircraft engines, see Aircraft engine. A Pratt Whitney F100 turbofan engine for the …   Wikipedia

  • Gas turbine — Microturbine redirects here. For turbines in electricity, see Small wind turbine. For turbines driven by the flow of gas, see Turbine. A typical axial flow gas turbine turbojet, the J85, sectioned for display. Flow is left to right, multistage… …   Wikipedia

  • Gas compressor — A gas compressor is a mechanical device that increases the pressure of a gas by reducing its volume. Compressors are similar to pumps: both increase the pressure on a fluid and both can transport the fluid through a pipe. As gases are… …   Wikipedia

  • Airbreathing jet engine — An airbreathing jet engine (or ducted jet engine) is a jet engine propelled by a jet of hot exhaust gases formed from air that is drawn into the engine via an inlet duct. All practical airbreathing jet engines are internal combustion engines that …   Wikipedia

  • Turbopump — As the name suggests, a turbopump comprises basically two main components: a rotodynamic pump and a driving turbine, both mounted on the same shaft. A turbopump can refer to either of two types of pumps either a centrifugal where the pumping is… …   Wikipedia

  • Centrifugal pump — Warman centrifugal pump in a coal preparation plant application A centrifugal pump is a rotodynamic pump that uses a rotating impeller to create flow by the addition of energy to a fluid. Centrifugal pumps are commonly used to move liquids… …   Wikipedia

  • Mixed flow compressor — For more details on this topic, see Centrifugal compressor. A mixed flow compressor combines the axial and radial components to produce a diagonal flow unit. The exit mean radius is greater than at the inlet, but the flow tends to exit in an… …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”