Humbucker

Humbucker

A conventional humbucker (or Humbucking pickup) is a type of electric guitar pickup that uses two coils, both generating string signal. Humbuckers have high output since both coils are in series and because the magnetic circuit is low loss. Like a single coil pickup, a humbucker induces a slight magnetic field around the strings which in turn induce an electrical current on the coils as the strings vibrate. But since the two coils are of reversed polarity and reverse-wound and connected in series, noise and interference is significantly reduced via common-mode rejection. They get their name because they cancel out a large portion of the interference (they "buck the hum") induced by alternating current sources normally experienced with single coil pickups.

Magnetic "hum" is mostly created by transformers and power supplies inside various electrical equipment utilizing household AC current. As AC current is put though a coil, it induces a magnetic field around the coil that quickly becomes weaker with distance. When it reaches the guitar pickup, the strength is very slight, but once put through various pedals and amps it becomes much more evident. Using a guitar without humbuckers, a musician would hear a slight but annoying hum at the amp at silent sections of the music piece. Sources of magnetic hum generated in the studio and on stage include, but are not limited to, high power amps, processors, mixers, motors, etc., as well as criss-crossing power lines. Humbuckers dramatically reduce the hum effect compared to single coil pickups.

Humbuckers are great at canceling out low sine wave frequencies (such as those produced by big AC transformers) but poor at canceling out higher frequencies and various harmonics (such as those produced by guitar strings).

History

This first "humbucker" or humbucking pickup was the so-called PAF (literally "Patent Applied For") invented by Seth Lover, a Gibson employee, in 1957. Because of this, and because of its use on the Gibson Les Paul guitar, the humbucker is strongly associated with Gibson, although humbuckers have been used in many different guitar designs by many different manufacturers. Humbuckers are also known as "dual-coil", "double-coil", or "hum-canceling" pickups. Rickenbacker offered dual coil pickups arranged in a humbucking pattern beginning in late 1953 but dropped the design in 1954 due to the perceived distorted sound. The Gibson Les Paul was the first guitar to use humbuckers in substantial production, but since then, even some models of Fender Stratocasters and Telecasters, traditionally fitted with single-coil pickups, are factory-equipped with humbuckers. Stratocasters fitted with one humbucker in the bridge position, resulting in a pickup configuration noted as H-S-S (starting at bridge pickup: H for humbucker, S for single coil) are referred to as "Fat Strats", because of the "fatter", "rounder" tone offered by the humbucking pickup.

How humbuckers work

In any magnetic pickup, a vibrating soft-magnetic guitar string induces an alternating current in its coil(s). However, magnetic coils also make excellent antennas and are therefore sensitive to electromagnetic interference caused by mains wiring (mains hum) and electrical appliances like transformers, motors, and computer screens. Guitar pickups pick up this noise, which can be quite audible, sounding like a constant hum or buzz.

A humbucker has two coils with opposing windings and polarities. The string motion induces current in both coils in the same direction. Electromagnetic interference, on the other hand, induces current in opposing directions in each coil because of the reversed winding and polarity. When the signals from both pickups are summed together, the noise is cancelled due to destructive interference, while the actual signal is increased due to constructive interference, thus dramatically improving the signal-to-noise ratio. This technique is called common-mode rejection by electrical engineers, and is also used in balanced lines in audio recording.

ound

Using two coils also changes the tone of the pickup. The humbucking pickup produces a "warm" and "fat" tone that has been popularly associated with Les Pauls and SGs, in contrast to the "bright" or "clear" tone of the single coil pickups that are typically used on Fender guitars such as the Stratocaster and Telecaster. However, there are humbucking pickups that have a bright tone, similar to that of single-coil pickups.

It is a common misconception that because the coils are at slightly different positions along the string some of the higher-frequency harmonics are diminished or cancelled out, thus producing this warmer sound. This is only true if the pickup's coils are in reversed phase, (i.e., a phase switch on Vol/tone). The main reason humbuckers sound different is that the two coils resonate at different frequencies causing a broad resonant peak in frequency response, a characteristic of the original Gibson humbuckers, and because any two pickups wired in series will attenuate some of the higher frequencies due to the summed impedance. In fact, not all humbuckers have two separate full-size coils with two separate rows of magnetic pole pieces facing the strings; see the paragraphs below about "stacked" and "rail" designs. The "stack" and "rail" pickups can still produce the "warm" and "fat" tone, in spite of sensing only a small section of the string, just like single-coil pickups. Humbucker pickups are also available in single coil size.

Usually, those who prefer the brighter sound of single-coil pickups have to simply live with the extra hum and buzz in order to get the tone they prefer, although technologies designed to preserve the tones exist.

Alternative humbucker designs

tacked humbuckers

Solid body guitars, such as Fender Stratocasters, usually feature cavities only for single-coil pickups. Installing full-sized humbuckers requires additional routing of the woodwork and cutting of the pickguard (if the instrument has a pickguard). If the process is not carefully done, the instrument's body and pickguard may be damaged and possibly affect the tone produced by the body. This is unacceptable, especially for expensive vintage guitars where it is vital to preserve cosmetic appearance. As a result, many pickup manufacturers now produce humbucking pickups compacted into the size of a single coil, accomplished by vertically "stacking" the coils instead of placing them side-by-side as in a regular humbucker. Many different kinds of stacked humbuckers are available from several manufacturers, producing a wide range of different tones.

Although the Fender Stratocaster-style single coil is by far the most frequently found pickup in a single coil size, humbuckers are available for most single-coil guitars. Fender produces several variations in their Telecaster, Jaguar, Jazzmaster, and Mustang guitars.

Rail humbuckers

Another design known as rail humbuckers divides a single coil-size pickup in half lengthwise, and the windings are wound around two pole pieces, typically resembling a rail. These pickups look like a normal, albeit smaller, humbucker. This, however, is typically used in conjunction with stacked humbuckers, to produce a high output pickup. This design can also extend to a "quadrail", by using a rail humbucker for each "single coil" of a normal humbucker.

The same type of rails can also be found in a normal-size humbucker, however. Heavy metal guitarist Dimebag Darrell made heavy use of this type of pickup wired in the bridge position. These tend to also sound fuller and have a higher gain and attack than the single coil-size version.

Coil splits

Some guitars which have humbucking pickups feature coil splits, which allow the pickups to act as "pseudo-single" coils. The electrical circuit of the pickup is reduced to that of a true single coil while the magnetic circuit retains its original closed loop configuration. Usually, this feature is activated using a switch on the tone potentiometer. Coil split turns on when potentiometer is pulled out and reverts back off when it is pushed in. This is often wrongly referred to as a "coil tap". Coil taps are more commonly found on single coil pickups, and involve an extra hook-up wire being included during the manufacture of the pickup so the guitarist can choose to have all the windings of the pickup included in the circuit, for a fatter, higher output sound; or some of the windings in use and some "tapped off" for a brighter, lower output, cleaner sound.

Notable humbucker designs

*Gibson "PAF" - Seth Lover's original humbucker design
*Fender Wide Range - Fender's first humbucker design, also by Seth Lover
*Gibson mini-humbucker - a smaller humbucker design used on the Gibson Firebird
*Q-tuner: neodymium magnet humbuckers

Other noise-reducing pickup designs

While the original humbucker remains the most common noise-reducing pickup design, inventors have tried many other approaches to reducing noise in guitar pickups.

Many instruments will use a combination of separate single coil pickups in a hum reducing configuration, where the magnetic polarity is different and the coils are electrically reversed. This arrangement is similar to that of a humbucking pickup and noise is effectively reduced. Some examples of this are the Fender Jazz Bass, introduced in 1960, which has used a pair of single coil pickups, one near the bridge and another one about half way between the bridge and the neck, and many Stratocaster style guitars, which often have 3 pickups with the middle one reversed electrically and magnetically. The (usually) 5-way selector switch allows 2 humbucking settings, where the reversed middle pickup is used in parallel with either the bridge or neck pickup.

In 1957, Fender introduced a split pickup to its Precision Bass, which was wired in humbucking fashion, with one coil serving the E and A strings, the other the D and G strings. Both coils pick up the same noise, but since each string is only served by one coil, a single-coil sound is provided. The concept of this later expanded to G&L's Z-coil pickup, which is used for standard guitars.

In 1985, Lace Music Products introduced the Lace Sensor pickups, which utilize a proprietary hum-screening technique to eliminate noise while preserving single-coil tone.

In 1996, Kinman Guitar Electrix introduced pickups based on a differential coil technology, essentially a stacked humbucker where the lower pickup coil functions solely as a noise sensing coil, while only the upper pickup coil is able to sense the string vibrations.

ee also

* Single coil
* Pickups

References

* US patent reference
number=2896491
y=1959|m=07|d=28
inventor=Seth Lover
title=Magnetic pickup for stringed musical instrument


Wikimedia Foundation. 2010.

Игры ⚽ Нужно решить контрольную?

Look at other dictionaries:

  • Humbucker —   [englisch, hʌmbʌkə], Tonabnehmer …   Universal-Lexikon

  • humbucker — /humˈbu kər/ noun An electric guitar pick up with two coils, designed to prevent unwanted noise ORIGIN: ↑hum1 and ↑buck1 (in sense of ‘oppose’) …   Useful english dictionary

  • Humbucker — Klassischer „PAF“ Humbucker mit Kappe auf einer Gibson Les Paul …   Deutsch Wikipedia

  • Humbucker — Pastilla humbucker tradicional, sin cubrir. El humbucker es un tipo de pastilla, utilizada en las guitarras eléctricas, que usa dos bobinas. Las humbuckers incrementan la salida, y debido a que la polaridad de las dos bobinas es inversa, el ruido …   Wikipedia Español

  • Humbucker — Un micro Humbucker et deux micros single coil Le Humbucker est un modèle de micro pour guitare électrique inventé par la firme Gibson dans les années 1950. Avant cette invention, les guitares électriques étaient pourvues de micros « simple… …   Wikipédia en Français

  • humbucker — noun A pickup, on an electric guitar, that has a pair of coils of reverse polarity connected in series to buck the hum . Syn: humbucking pickup …   Wiktionary

  • humbucker — /ˈhʌmbʌkə/ (say humbukuh) noun Music a guitar pick up that has two single electric coils wired together to produce a richer tone. {from the phrase to buck the hum . See hum1 (def. 10) …  

  • Mini-humbucker — The mini humbucker is a humbucking guitar pickup (used in electric guitars) originally created by The Epiphone Company. This pickup resembles a small Gibson PAF humbucker although, it is constructed differently and produces clearer, brighter… …   Wikipedia

  • P-90 — For other uses, see P90 (disambiguation). P 90 Manufacturer Gibson Period 1946–1957, reissues since 1968 …   Wikipedia

  • Fender Stratocaster — Stratocaster redirects here. For the Squier Stratocaster, see Squier Stratocaster. Fender Stratocaster Manufacturer Fender …   Wikipedia

Share the article and excerpts

Direct link
Do a right-click on the link above
and select “Copy Link”